Croydex GP78100 Manual

Croydex, Central Way, Andover,
Hampshire, SP10 5AW, UK [phone] [phone] [e-mail] www.croydex.com
1 2
3
R&R 061 R04
Always take care when using power tools,
particularly if there is any water in the
working area.
Do not use a hammer drill when drilling into a
tiled surface.
Always use a drill bit that is suitable for the
surface that is being drilled.
The wall plugs supplied are for use on solid
walls only. For cavity walls or plasterboard use
specialist fixings that are suitable for the type
of wall construction.
4
To retain the best quality finish, clean product
regularly with a soft damp cloth.
Do not use abrasive or chemical cleaners, as
these will damage the product.
Do not use this product as a grab bar.
If the gliders become sticky, use a small
amount of furniture polish to improve
performance.
Do not overload the rail. Suitable for use with
a maximum of two standard shower curtains.
SAFETY AND CARE
x1 (2)
x1
x12 (24) x1 (2) x1 (2) x5 (6) x5 (6)
x1 (2)
x1 (2)
x1
x1 (2)
x2
Min
150mm
Remove the end brackets from the Bendy Rail. Form the Bendy Rail to your desired size and shape.
The minimum bend radius is 150mm.
Once you have bent your rail, DO NOT make
any attempt to undo the bend as this will
separate the rail components and cause the
hooks to fall out.
After the rail has been bent, cut the rail ends straight
as shown.
Quantities of parts may vary due to product sizes.
Hold the rail in the
desired position
ensuring there
is adequate
curtain overlap
into the bath
or shower tray.
Mark the position of
each wall bracket on the
mounting surface. Use
a spirit level to ensure it
is level.
5 6
At this stage, measure the distance between the top
of the wall bracket and the ceiling.
Using this measurement, cut the ceiling support rod
to length for use later.
??
x2
2x
x3

Croydex, Central Way, Andover,
Hampshire, SP10 5AW, UK [phone] [phone] [e-mail] www.croydex.com
Slide the end stops to the desired
locations and twist the hook to lock
it in position.
Then add a hook onto the end stop.
Insert the ceiling support rod into the ceiling bracket
and secure in position using the small screw provided.
10
11
R&R 061 R04
12 14
17
Secure the ceiling bracket to the ceiling using the fixing
screw provided.
Tighten the screws on the top
face of the wall bracket into the
securing component to lock the
rail in position.
Insert the hook gliders and end stop into the bottom
channel of the Bendy Rail ensuring the end stop is at
the end closest to the showering unit.
Attach the rail assembly to both wall brackets by
sliding the upper section onto each bracket.
Assemble the ceiling support rod. Slide the ceiling support rod into the top section of
Bendy Rail.
Insert the top channel spacers into the upper
channel on the rail and space them evenly across the
length of the rail. Use all 3 spacers.
13
Separate the ceiling bracket from the assembly then
mark the centre, drill and insert a wall plug in the
position marked on the ceiling.
9
Mount the wall bracket to the mounting surface using
the screws provided.
Place the Bendy Rail into the wall brackets and slide
the ceiling support rod into the desired position. Mark
the location of the ceiling bracket on the mounting
surface ensuring it is vertical.
16 1815
Plastic washer
7 8
Place the wall brackets in position and mark hole centres.
Drill the mounting holes and insert wall plugs.