Croydex QM391941 Manual

Thank you for purchasing this Croydex product. Please follow the fixing and care instructions to ensure
your Stainless Steel Wire Storage product is fitted safely and retains its high quality finish.
Please retain this leaflet for future reference.
This instruction leaflet applies to the following Stainless Steel Wire storage products:
QM391941 STAINLESS STEEL SOAP DISH
QM390941 STAINLESS STEEL CORNER SOAP DISH
QM390641 STAINLESS STEEL COSMETIC BASKET
QM395941 STAINLESS STEEL CORNER BASKET
QM390841 STAINLESS STEEL SMALL TWO TIER CORNER BASKET
QM390241 STAINLESS STEEL MEDIUM TWO TIER CORNER BASKET
QM393841 STAINLESS STEEL LARGE TWO TIER CORNER BASKET
QM394341 STAINLESS STEEL HOOK-OVER THREE TIER BASKET
Fixing Pack Contents
Fixing Screws x 2
Wall Plugs x 2
Please note, QM394341 HOOK OVER THREE TIER BASKET does not contain fixing screws and wall plugs.
This item can be hooked over shower screens and enclosures.
Only use the fixings supplied.
Tools Required
Drill; 6mm masonry drill bit (6mm ceramic drill bit optional); Cross head screwdriver; Pencil; Spirit level.
KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN
Home Safety Advice
Always take care when using an electric drill, particularly in the bathroom. Always check for hidden
cables and pipe work before drilling and take extreme care if there is any water in the working area.
It is advisable to use a residual current circuit breaker (RCCB).
Always wear suitable eye protection when drilling.
If the product is to be fitted on a ceramic tiled wall, a ceramic drill bit should be used. Always ensure
that the drill hole passes through the central tiled area rather than through the grouted area. To prevent
damage to the tile, mask the area around the hole with tape before drilling.
Do not strike the product with hard or sharp objects.

Fitting Instructions
1. Select position of the product on the wall and mark through the fixing holes, ensuring that where
applicable, the product is level.
2. Remove the product. Using a 6mm masonry drill, drill the holes in the marked positions to a depth of
30mm. If drilling through tiles, please pre-drill using a ceramic drill bit. Insert the wall plugs to the
surface of the wall. If fitting to a tiled surface, the wall plugs should be inserted below the surface of
the tile to avoid cracking.
3. Insert the screw(s) through the holes on the product and screw into the wall plug(s). Do not over
tighten as cracking of the tiles could occur.
Product Care
To retain the best quality finish, clean product regularly with a soft cloth and mild detergents. Do not use
abrasive or chemical cleaners, as these will damage the product.
Please retain this leaflet for future reference.
Croydex Limited, Central Way, Andover, Hants, SP10 5AW, UK
Tel: [phone]. Fax: [phone]
Website: www.croydex.co.uk. E-mail: [email protected].
WMA 059 R01

Pdf Supplied By http://www.plumbworld.co.uk/