Croydex Hampstead Wall Mounted Accessory User manual

Hampstead Wall Mounted Accessory Fitting Instructions
Thank you for purchasing this Croydex product. Please follow the fixing and care
instructions to ensure that your accessory is fitted safely and that it retains its high
quality finish. Please retain this leaflet for future reference.
Fixing Pack Contents
Long Fixing Screws x 2 (4) (Double Mounting)
Wall Plug x 2 (4) (Double Mounting)
Wall Fixing Bracket x 1 (2) (Double Mounting)
Contents supplied will vary depending on the product. The quantities shown above
in brackets are for double bracket fixings.
NOTE - The wall plugs supplied are for solid walls only, use appropriate
fixings for cavity walls.
Tools Required
Drill ; Pencil; 6mm masonry drill bit; 6mm ceramic drill bit (optional); Spirit level;
Small flat head screwdriver; Cross head screwdriver; Tape measure.
KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN
Safety and Care Advice
1. Always take care when using an electric drill, particularly in the bathroom.
Always check for hidden cables and pipework before drilling. Always use a
residual current circuit breaker (RCCB) when using mains powered tools
and take extreme care if there is any water in the working area.
2. Always wear suitable eye protection when drilling.
3. If the product is to be fitted on a ceramic tiled wall, a ceramic drill bit
should be used. Do not drill mounting holes in the grouted area between
tiles. Mask the area around the hole with tape before drilling to prevent
damage to the tile.
4. Do not use the product as a grab bar.
Fitting instructions for items with single and double mounting points:
1. Select position of product and mark its centre on wall. (Refer to Fig. 1 for
centre positions of double mounting items.) Centre the wall fixing
bracket over the mark and using it as a template mark the screw fixing
positions on the wall surface.
2. Drill the holes to a depth of 40mm in the marked positions using a 6mm
masonry drill. If the product is to be fitted onto a ceramic tiled wall, a
ceramic drill bit should be used.
3. Insert the wall plugs flush to the surface of the wall. If fitting to a tiled
surface the wall plugs should be inserted below the surface of the tile to
avoid cracking.
4. Insert the screws provided through the wall fixing bracket and screw into
the wall. Ensure the wall bracket is level.

5. Using a small flat head screwdriver loosen the grub screw within the
backplate. Place the backplate on the wall bracket and tighten the grub
screw as shown in Fig. 2.
Fig.1
Fig.1
Fig.1 Fig.2
Additional Information
Maximum safe working load for the shelf is 5kg. This load must be evenly
distributed across the surface area of the shelf.
Product Care Advice
• To retain the best quality finish, clean product regularly with a soft damp cloth.
• Do not use abrasive or chemical cleaners, as these will damage the product.
• Do not place hot objects onto the surface of the glass.
• Do not position glass components in close contact with a heat source.
Croydex Limited, Central Way, Andover, Hants, SP10 5AW, UK
Tel: [phone]. Fax: [phone]
Website: www.croydex.co.uk. E-mail: [email protected]
WMA 034 R01