D-CUT XP-215 User manual

OPERATION MANUAL
D-Cut Laminate Cutter XP-215
www.dcutproducts.com
CUTTING AND C

2
The Slot on the Cutter Base
On the cutter base, there are a few sets
of the slot used for the stopper
attachment. Always use the slots closer
to the pivot of the blade according to
the width of the plank. The closer to the
pivot of the blade, the more cutting
power you will get.
Free Angle Cut
Mark a line of the floor plank and
remove the stopper attachment from
the cutter base. Line up the blade with
the line marked on the plank, then push
down the blade by using the handle.
The small teeth located along the
cutting slot will keep the laminate plank
from slipping. If the cut is longer than
20cm (8 inch) it is recommended to
make a few cuts with the increment of
5cm (2 inch) for each cut in order to
follow the marked cutting line. After
making each cut pull the handle back
up. Slide the cut portion of the flooring
towards the pivot of the blade and cut
again. Repeat the procedure until the
full length of the cut is completed.
Straight Cut
Place the flooring plank onto the cutter
base and position the stopper in the
appropriate slot at the required length.
Then push down the blade by using the
handle. The cutter is designed to cut
through laminate pieces by removing a
small amount of laminate.
Please note that a slightly rough edge
is normal. The cut edge will meet the
wall and be covered by a molding (a
base board or a quarter-round).

3
Carry
Hook the chain to the ring on the
handle and carry the cutter as shown.
“L” Cut
When making an “L” cut, it is
recommended to cut the lengthwise first,
following the “Lengthwise Cut” procedure
to cut plank to the required point and then
re-position the plank, make a last cut
“cut-out”.
Lengthwise Cut
When cutting laminate lengthwise, remove
the stopper from the cutter base. Mark a
line on the laminate plank and place it on
the base. Hold it down firmly while pushing
down the cutter blade. Small teeth located
along the cutting slot will keep the laminate
plank from slipping. If the cut is longer than
20cm (8 inch), it is recommended to make
a few cuts with the increment of 5cm (2
inch) for each cut in order to follow the
marked cutting line. After making each cut
pull the handle back up. Slide the cut
portion of laminate towards the pivot of
the blade and cut again. Repeat the
procedure until the full length of the cut is
completed.

4
Part List
Parts Q’ty Parts Q’ty
1 Steel Teeth 2 14 Supporting Bar 2
2 Working Table 1 15 End Cap 2
3 Blade 1 16 Base 1
4 Customized Bolt 1 17 Chain 1
5 Blade Holder 1 18 Hook B 1
6 Solid Rivet 4 19 Rubber Feet 5
7 Rubber Pad 1 20 Blind Rivet 5
8 Handle 1 21 Stopper Attachment 1
9 Hook A 1 22 Ash-bin 1
10 Right ABS Handle 1 23 Supporting Stand 1
11 Nut M4 2 24 Flange Nut 1
12 Left ABS Handle 1 25 Blade Stopper 1
13 Cross Head Screw M4 × 31 2