D-CUT LU-215 User manual

OPERATION MANUAL
D-Cut Laminate Cutter LU-215
www.dcutproducts.com
CUTTING AND C

2
Assembly
Use provided Allan wrench, screws,
bolt and nuts to assemble the blade
onto the base and handle as shown.
Warning:
Avoid contact with the steel teeth along
the cutting slot, which may cause
injury.
Cross Cut
Place the flooring plank onto the cutter
base and position the stopper in the
appropriate slot at the required length.
Then push down the blade by using the
handle. The cutter is designed to cut
through laminate pieces by removing a
small amount of laminate.
Please note that a slightly rough edge
is normal. The cut edge will meet the
wall and be covered by a molding (a
base board or a quarter-round).
Free Angle Cut
Mark a line of the floor plank and remove
the stopper attachment from the cutter
base. Line up the blade with the line
marked on the plank, then push down the
blade by using the handle. The small teeth
located along the cutting slot will keep the
laminate plank from slipping.
After making each cut pull the handle back
up, the small pin featured on the blade
helps to move the plank forward. Use your
hand to push down the plank and then cut
again. Repeat the procedure until the full
length of the cut is completed.

3
“L” Cut
When making an “L” cut, it is
recommended to cut the lengthwise
first, following the “Lengthwise Cutting”
procedure to cut plank to the required
point and then re-position the plank,
make a last cut “cut-out”.
Lengthwise Cutting
When cutting laminate lengthwise, remove
the stopper from the cutter base. Mark a
line on the laminate plank and place it on
the base. Hold it down firmly while
pushing down the cutter blade. Small teeth
located along the cutting slot will keep the
laminate plank from slipping.
After making each cut pull the handle back
up, the small pin featured on the blade
helps to move the plank forward. Use your
hand to push down the plank and then cut
again. Repeat the procedure until the full
length of the cut is completed.
Carry
Hook the chain to the ring on the
handle and carry the cutter as shown.

4
Part List
Parts Q’ty Parts Q’ty
1 End Cap 2 15 Working Table 1
2 Screw M6×15 4 16 Stopper Assemble 1
3 Spring Washer Φ6 8 17 Left Steel teeth 1
4 Flange Nut M8 1 18 Locker Nut 5
5 Blade 1 19 Blade Base
1
6 Knurled Thumb Screw 1 20 Customized Screw M10 1
7 Handle 1 21 Washer
1
8 Right ABS Handle 1 22 Screw 4
9 Thin Nut M4 2 23 Rubber Foot 3
10 Customized Screw M4 2 24 Rivet 6
11 Left ABS Handle 1 25 Cutter Base 1
12 Hook A 1 26 Supporting Stand 1
13 Rubber Pad 1 27 Allan Wrench 1
14 Hook B 1 28 Spring Pin 2