Dancover GH82020 User manual

13-04-2015
for
Polytunnel greenhouse
4x6,25x2,4m
Manual

Safety Advice
Attention
In some countries approval is needed to set up a marquee/tent larger than 75 m2. It is
your responsibility to comply with local rules and regulations and to ensure that the
marquee/tent is assembled correctly.
In case of bad weather conditions, it is your responsibility to ensure the marquee/tent is
safely secured and that the marquee/tent does not cause damage to others.
close to the tent.
The marquee/tent must be safely secured. We recommend you secure your marquee/tent
with straps and pegs as soon as it is assembled.
Make sure to check if the marquee/tent is covered by your home contents
insurance.
Marquees/tents must be evacuated under extreme weather conditions.
In the event of snow always remove snow from the roof of the marquee/tent regularly to
prevent snow from building on the roof as heavy snow can cause the marquee/tent to
collapse.
In the event of rain there is a risk of rain puddles building up on top of the roof of the
marquee/tent. Heavy rain puddles can cause the roof to collapse. It is your responsibility
to ensure rain puddles do not build up. As a precaution, make sure the roof of the
marquee/tent is stretched out properly and adequately over the side frames of the
marquee/tent and remove rain water regularly.
Do not unpack or repack your marquee/tent in freezing temperatures. In case of
temperatures below zero always unpack and repack your marquee/tent indoors to avoid
the risk of cracking parts.
The marquee/tent must be totally dry before you repack and store it to avoid mildew.
Warranty Information
Please visit dancovershop.com for information on warranty.
Please always check our website for the latest safety advice and manuall.
This structure is not tested for snow and wind loads. We always recommend that you
remove snow from the roof.

Symbol Name of the part Length: [cm]
1A One-side side bow R
1B One-side side bow L
1C Front one-side bow
1D Side reversible bow
1E Top reversible bow
2Front horizontal connector 131
2A Front horizontal connector with coupler 131
3Horizontal connector 121
4Bows connector 126
5Vertical connector (door frame) 180
6Post 80
7Corner reinforcement 120
8Top horizontal reinforcement 114
8A Top horizontal reinforcement with couple 114
9Door vertical cross bar 172
10 Door horizontal cross bar 90
11 Door reinforcement 170
12 Clamp fi25
13 Reversible clamp
14 Middle connector
15 Corner connector
26 Bolt M6x40 + nut
27 Nut M8
28 Clips
31 Hinge
32 Sprung sliding bolt 100
34 Foil UV
Number [pcs.]
2
8
2
2
4
25
4
2
12
4
12
4
4
4
6
6
32
8
2
24
4
160
16
80
11,5 lm
4
2

6,75m 4,5m
2,25m
2,25m
Cover
The cover comes in 1 piece. Cut the cover into 5 pieces. Use the measurements shown below.
T
he “Main part of the tunnel” piece is 1m extra long on both sides. The extra cover must be dug into the
g
round to secure the polytunnel greenhouse.
C
onnect the cover to the frame with the easy clip-on connector system.