6933.AUDI02 3.16.195.3 2017 Audi Q5
©2022 VOXX•DEI LLC. All rights reserved.
Refer to "Pre-installation and application warnings" for important information, such as the description of each special note referenced in the diagram ( ).
Wiring diagram - Key Release Type 1
(-) Ground: Black: 10
(-) Starter Output: Lt. Blue/Black: 10
(-) Keysense Output: Lt. Green/Black: 1
(+) Brake Activation Output: Violet/Black: 8
FT CAN High: Orange/Green: 4
FT CAN Low: Orange/Brown: 3
HS CAN High: Tan/Black: 2
HS CAN Low: Tan: 1
Hood Pin
(-) Hood Input: Gray: 21
Siren
(+) Siren Output: Brown/Red: 11
Ignition Switch
(16-pin, black connector)
3x 1A
Diodes
FT CAN High: Orange/Green
FT CAN Low: Orange/Brown
Twisted pair
(in driver’s kick panel, door harness)
(-) Starter 3:
Black/Red,
pin 14
(-) Starter 2:
Gray/Blue,
pin 13
(-) Starter 1: Black or Black/Blue, pin 6
(+) Key Release:
Gray/Yellow, pin 15
(-) Keysense:
Black/Yellow, pin 5
Brake Wire
(at brake switch)
3
4
2
1
(+) Brake:
Red/Black, pin 3
Key Wrap: Lt. Green: 8
Key Wrap: Lt. Green/Red: 7
16
8
9
1
HS CAN Low: Orange/Brown, pin 14
HS CAN High: Orange/Red, pin 6
OBDII Diagnostic
(connector side view)
(+) 12V Input: Red: 6 & 12
(+) 12V Input - Type 1: Blue: 3
Refer to the
Vehicle connections
section for pin, wire
and connector details.
(+) Key Release Output - Type 1: Blue/Red: 2
(-) Clutch Activation Output: White: 5 & 11
(-) GWA (Ground While Armed) Output: Blue/White: 2
Security Only
Mandatory Connections
Remote Start Only
Legend:
Remote Start + Security
22 812
4 2442
Slide to open
A module can also be used for
this installation.
IMPORTANT:
Position the
fuses correctly!
MAIN (5A) (+)
(-) RLY3 PK LIGHT (15A) (+)
(-) ACC & START (30A) (+)
(-) FLEX RLY (20A) (+)
IGN (20A) (+)
MAIN (5A) (+)
(-) RLY3/PK LIGHT (15A) (+)
5
5
30
20
20
15
15
Refer to the
Optional starter
disable connection
section.
BCM
Gray/Yellow
Key Release Voltage Test
Type 1:
Follow this installation if Gray/Yellow test:
1. IGN OFF: 0 Volts
2. IGN ON: 0 Volts
Type 2:
Follow the installation on the next page if
the Gray/Yellow wire tests with the
following results:
1. IGN OFF: 0 Volts
2. IGN ON: 12 Volts
Without Push Button Start Switching the ignition on/off
•Insert the key into the ignition lock.
•Press the key briefly without pressing the clutch pedal (for
manual transmissions) or the brake pedal (for automatic
transmissions).
•To switch the ignition off, press the key again.
Using a multimeter, follow the type that corresponds with
the key release wire test:
