DMP Electronics myQ 736Q Assembly instructions

736Q myQ® INTERFACE
MODULE
Installation Sheet
DESCRIPTION
Figure1: 736Q myQ Interface Module
INPUT
FROM CONTROL
OUTPUT
TO OPENER
The 736Q myQ Module interfaces
myQ and Security+ 2.0 garage door
openers with Z-Wave garage door
controllers. For instance, connect
the 736Q to a Z-GDZ Z-Wave
Garage Door Controller to allow the
garage door to be controlled with
Virtual Keypad™.
Compatibility
• Z-GDZ Z-Wave Garage Door
Controller
• myQ Garage Door Openers
• Security+ 2.0 Garage Door
Openers
What is Included?
• One736Q myQ Interface Module
1SELECT A LOCATION
The 736Q connects to the garage door opener as a wall controller.
If a wall controller is already installed, connect the module wires
to the same terminals as the existing controller. Terminals for
wall controllers are typically the leftmost red and white terminals
located on the back of the opener housing. For more information,
refer to Figure 2.
Before wiring the module, select a location away from large metal
objects or sources of electrical interference. Interference may cause
the module to not work properly and can cause the garage door to
open unexpectedly.
WIRE THE 736Q
2Caution: Disconnect all power from the garage door opener
and controls before wiring the 736Q. Failure to do so may
result in equipment damage or personal injury.
Observe polarity when wiring the module.
1. Connect the red wire from OUTPUT TO OPENER to the red
garage door opener terminal.
2. Connect the black wire from OUTPUT TO OPENER to the
white garage door opener terminal.
3. Connect the red and black wires from INPUT FROM
CONTROL to the appropriate control terminals.
4. Restore power to the garage door opener and control.
INPUT
FROM CONTROL
OUTPUT
TO OPENER
From
Z-Wave
Device
RED
BLACK
RED
RED
WHITE
BLACK
Garage Door
Opener
Figure2: 736Q Wiring

Designed, engineered, and
manufactured in Springfield, MO
using U. S. and global components.
LT‑1978 19333
INTRUSION • FIRE• ACCESS• NETWORKS
2500North Partnership Boulevard
Springfield, Missouri65803‑8877
800.641.4282 | DMP.com
736Q myQ INTERFACE
MODULE
Specifications
Dimensions 3.0”H X1.4”W X0.6”D
Compatibility
Z‑GD00Z Z‑Wave Garage Door Controller
myQ Garage Door Openers
Security+ 2.0 Garage Door Openers
INPUT
FROM CONTROL
OUTPUT
TOOPENER
3Mount the 736Q with screws or double-sided tape.
After restoring power to the system, allow the module to boot up for at least 30seconds before attempting to
sync the garage door opener.
To sync the module and garage door opener, activate the control connected to the 736Q. Repeat this step until
the garage door opens when the control is activated.
MOUNT AND SYNC THE 736Q
ADDITIONAL INFORMATION
Troubleshooting 736Q Operation
If the garage door does not respond to control activation, complete the following troubleshooting steps.
1. Ensure the module and connected devices have power.
2. Ensure all wiring connections are correct.
3. Sync the control and garage door opener.
4. Check for sources of interference, such as metal objects or electronic equipment. Move the module if necessary
until the garage door opener successfully syncs with the control.
Safety Information
When using the 736Q to open or close garage doors, follow these safety procedures to avoid potential injury:
• Only install the module on sectional garage doors
• Only install the module on garage doors with openers that have secondary protection systems, such as
photoelectric sensors
• Install additional parts and equipment that provide audio and visual alerts when the garage door starts opening or
closing
Virtual Keypad
For information about managing Z-Wave garage doors and other home automation devices, refer to Virtual Keypad App
Help.