DREAMS HouseBeautiful Maisy bed User manual

M ai s y
Two person
assembly
1 hour approx
assembly time
bed

Maisy Bed - Assembly Guide - Page 2

3
Maisy Bed - Assembly Guide - Page
Bed Bed Size Min Weight
(kg)
Max Weight
(kg)
Double 20 45
King 45
Superking 30 55
20
Maisy bed
DON' T LIFT WITHOUT MATTRESS ENSURE MATTRESS IS ON
BEFORE LIFTING
IMPORTANT OTTOMAN SAFETY WARNINGS
IMPORTANT – READ CAREFULLY – RETAIN FOR FUTURE REFERENCE
You must ensure that the mattress is on the bed frame before operating the
lift mechanism – Failure to do so could result in injury.
Keep hands clear of the mechanism when opening or closing the ottoman.
Beware ofentrapment – Never reach in through the mechanism to access
the storage area.
Always ensure that the ottoman is FULLY opened before accessing the
storage area.
Do not reach into the storage area through the hinge mechanism.
Do not exceed the maximum weight as specified in the table below:
Use caution when operating, always use the handle when lifting
Note: This bed uses a pressurised mechanism.
To be operated by adults only
Please ensure that children and pets are kept away from the bed when
operating the lift mechanism.
Keep children and pets away from the storage area.
No children or animals are left unattended when the frame is in the ’ up’
position.
Do not overload the internal storage base.
Do not stand inside the internal storage area of the bed
Before removing the mattress secure the frame to ensure it does not open
unexpectedly.
Do not attempt to lie on the mattress when the ottoman is in the raised
position.
When lifting the ottoman remove all bedding except the fitted sheet.
Depending on the weight of the mattress, the rising speed will vary so be
careful until you get used to the speed.
NOTE: When fully assembled and the mattress is in position, please raise and
lower the ottoman 4 / 5 times to ensure the gas pistons are fully lubricated.

Parts list
1. H ead board x 1
. Footboard x 1
Parts
. leg x
. Right Side Rail x 1
. Left Side Rail x 1
. Support Wood x
. Baseboard x 1
. Centre Supporter x 1
. Slat Frame x 1
. Mattress holder x
2
3
4
2
5
4
6
7
8
9
11
. Slat Frame x 1
10
2
4
Maisy Bed - Assembly Guide - Page

5
Screws (M x mm)
8 38
Washers (M x mm)
8 23 Spring Washers (M )
8Bolts (M x mm)
8 18
Allen Key (for M bolt)
8Bolts (M x mm)
8 65 Bolts (M x mm)
8 45 Bolts (M x mm)
8 25
Bolts (M x mm)
8 80
Felt Pads
Brack ets
Spanner (for M nut)
8
Nuts (M )
8
A x pcs
8B x pcs
38 C x pcs
6D x pcs
8
E x pc
1
M x pc
1
F x pcs
6G x pcs
8H x pcs
12
K x pcs
4
J x pcs
8
I x pcs
6
N x pcs
8
L x pcs
12
Bolts (M x mm)
8 20
Maisy Bed - Assembly Guide - Page

6
Step 2
Step 1BC
F
E
Allen Key x 1 (for M bolt)
8
Washers x (M x mm)
6 8 23
Bolts x (M x mm)
6586
Spring Washers x (M )
6 8
F
E
C
B
N
Screws x (M x mm)
4 8 38
N
A
Bolts x (M x mm)
2084
A
B
Washers x (M x mm)
4 8 23
B
E
Allen Key x 1 (for M bolt)
8
E
2
2
5
2
Attach x support woods ( ) to the footboard ( ) with x bolts mm (F),
2526 65
x washers (B) and x spring washers (C) by using allen k ey (E) and
6 6
x screws mm (N) by using phillips head screwdriver (not provided).
4 38
Attach x legs ( ) to the bottom of support
wood ( ) with x bolts mm (A) and x washers (B) by using allen k ey (E).
2 6
5 4 20 4
2
Maisy Bed - Assembly Guide - Page
6
5

7
Step 4
Step 3A
Bolts x (M x mm)
2084
B
Washers x (M x mm)
4 8 23
E
Allen Key x 1 (for M bolt)
8
A
B
E
6
D
Bolts x (M x mm)
1884
1
D
Attach x legs ( ) to the bottom of headboard ( )
with x bolts mm (A) and x washers (B) by using allen k ey (E).
2 6
4 20 4
1
Install x bolts mm (D) to the holes in the headboard (1) as shown by hand.
4 18
Note: Do not tighten fully but leave mm gap as in the diagram.
10
Maisy Bed - Assembly Guide - Page
1
1

8
Step 6
Step 5D
Bolts x (M x mm)
1884
D
2
E
Allen Key x 1 (for M bolt)
8
2
3
4
E
Install x bolts mm (D) to the holes in the footboard ( ) as shown by hand.
4 18
Note: Do not tighten fully but leave mm gap as in the diagram.
10
2
Attach side rails ( and ) to headboard (1) and footboard ( ) by Allen k ey (E) as shown.
3 4 2
Maisy Bed - Assembly Guide - Page
2
134
1

Step 8
Step 7HJI
Bolts x (M x mm)
25812 Brack ets x 6Felt Pad x 6
I
H
Attach x brack ets (I) to the headboard (1), side rails ( and ) and footboard ( ) with
63 4 2
x bolts mm (H) by using phillips head screwdriver (not provided).
12 25
Stick the felt pad (J) on each top of brack et (I).
2
4
J
Maisy Bed - Assembly Guide - Page 9
1
3
Put the baseboard ( ) inside of bed. Attach the velcro to the four edges of frame.
7
7

10
Step 9
3434
Maisy Bed - Assembly Guide - Page
2
7
7
2
2
3
4
1
7
Note: The two wings of baseboard should be attach to the support wood ( ) of footboard.
5
Pl eas e do n ot s tore i tems on s i de p an el s