DREAMS WOODSTOCK User manual

Woodstock –Double Bed / King Bed
Page 1 of 5
Assembly Instructions
1. We suggest you spend a short time reading through this leaflet and then follow
the simple step by step instructions.
2. If you follow the instructions carefully the end result should be worth the effort.
3. Do not discard any of the packaging until you have checked that you have all
the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings are only
finger tightened during initial assembly. Only upon completion of the assembly
should all fixing points be fully tightened.
6. We recommend a periodic check on all fixing points to make sure they remain
fully tightened.
7. Keep glue and fittings out of children’s reach.
the unlikely event that this product has missing or damaged parts, please call
0344 292 0000 to obtain spares
spare
Before you
Start, here
are some
helpful
advices.

M6×45mm x 6pcs
M6 × 6pcs
Allen Key M4 x 2pcs
Metal washer x 6pcs
Screw 35mm x 1pc
Page 2 of 5
PARTS Fittings
NO. PART LIST QTY
(1) Headboard 01
(2) Footboard 01
(3) Side Rails 02
(4) Support Leg 01
A
B
D
C
E

Page 3 of 5
ASSEMBLY
STEP1
- Use bolt (mounted on the
headboard and footboard) to
fix the side rail (3) onto
headboard (1) and footboard
(2) by using Allen Key (C).

Page 4 of 5
ASSEMBLY
STEP 2
NOTE: You have bought your bed,
choosing one of two slat options;
either solid or sprung. Although
both assembly options are
explained here only one will apply
to you. Please follow the correct
procedure for the slat system which
you have chosen.
Both slats on "step 2" and "step 3"
can be assembled to the bedstead.
You can make a choice between the
two slats.
OPTION"A": DREAMS FIXED
WOOD SLATS
(1) Carefully locate the slats
onto the unit, as step 2:
Use bolt (A), washer (D) and
JCN nut (B) to fix the unit
using Allen Key (C)
(2) Fit the adjustable support
wooden leg (4) to the center
slat. Secure with screw (E)
using screwdriver (not
provided).
Not included

Page 5 of 5
ASSEMBLY
STEP 3
OPTION"B": DREAMS
SPRUNG SLATS
(1) Use the bolt to fix support
leg onto the slat frame.
Please note that these bolts
are to be found inside the slat
frame box.
(2) Carefully locate the slats
onto the unit.
(3) Use bolt (A) and JCN nut
(B) to fix the unit using Allen
Key (C).