DREAMS VALENCIA User manual

1 of 5
VALENCIA SINGLE BED (GUEST UNIT)
Assembly Instructions
NOTE: It will require two people to assemble this bed. Assembly should be carried out in the room that
the bed will be used in.
1. We suggest you spend a short time reading through this leaflet and then
follow the simple step by step instructions.
2. If you follow the instructions carefully the end result should be worth the effort.
3. Do not discard any of the packaging until you have checked that you
have all the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings are only
finger tightened during initial assembly. Only upon completion of the assembly
should all fixing points be fully tightened.
6. We recommend a periodic check on all fixing points to make sure they remain
fully tightened.
7. Keep glue and fittings out of children’s reach.
In the unlikely event that this product has missing or damaged parts, please call
0870 3333 612 to obtain spares
Before you
Start, here
is some
helpful advice
Caution when unpacking the
guest unit. The legs are spring
loaded and if opened without due
care can cause injury.

2 of 5
Component parts and fittings contained in the box
PARTS Fittings
A
B
C
D
E
F
G
H
I
JCN Nut 6pcs
4MM Allen key 1pc
Connector 4pcs
Connecting bolt 4pcs
M6 x35mm 6pcs
Spanner 1pc
Ɏ8 Spring Washer 4pcs
M8 Nut 4pcs
Ɏ10x40 Dowel 8pcs
1 piece
1 piece
1 piece
2 pieces

3 of 5
ASSEMBLY
1) Screw the connecting bolt “B” into the
headboard “1”and footboard “2”.
1) Knock the dowels “I” into the holes
indicated on the side rail “3”.
2) Carefully fit the side rail to the
head&foodboard .
Use connectors “A”, spring washer “F” and
Nuts “E” to fix the unit (see inset).
STEP 1
STEP 2

4 of 5
ASSEMBLY
To store the Guest bed under the single bed,
first ensure that the legs are retracted, before
sliding the Guest bed under the single bed.
(see inset)
STEP 3

5 of 5
ASSEMBLY
NOTE: Slats not supplied shown for
reference only.
Both slats on “step4-5” can be
assembled to the bedstead.you can to
make a choice beteen the two slats.
1) Carefully locate the slats frame onto the bed.
2) Use bolt “C” and Jcn nut “G” to fix the slats
frame onto the bed.
1) Carefully locate the slats frame onto the bed.
2) Use bolt “C” and Jcn nut “G” to fix the slats
frame onto the bed.
STEP 4
STEP 5