Drive Clever-Lite LS Installation instructions manual

of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards
and carefully inspected prior to shipment. This
Lifetime Limited Warranty is an expression of our
confidence in the materials and workmanship of
our products and our assurance to the consumer
of years of dependable service.
In the event of a defect covered by this warranty,
we will, at our option, repair or replace the device.
This warranty does not cover device failure due to
owner misuse or negligence, or normal wear and
tear. The warranty does not extend to non-durable
components, such as rubber accessories, casters,
and grips, which are subject to normal wear and
need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
Port Washington, NY 11050
MADE IN CHINA
© 2002 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
LIFETIME LIMITED
WARRANTY
Instructions & Warranty
www.drivemedical.com
Clever-Lite LS
Item #10233 Shown

Do
not
attempt
to
adjust
or
operate
walker
without
carefully reading all instructions in this manual.
Wide
Comfortable
Seat
OrthodicHand Grips
Trigger release
allows easy
folding
Backrest
Sealed Wheel
Bearing for
Smooth Operation
Item #10233
Push Lock Style
Assembly Instructions:
Safety Precautions:
First remove all contents from carton: backrest,
handle with tube, Walker frame and basket.
Open Frame and slide padded backrest into frame
brackets making sure snap bottons protrude
through holes.
Unscrew tightening knob from handle and insert
handle tube into frame at desired height lining up
holes appropriately. Slide bolts through holes from
the inside and screw on tightening knob until secure.
1
2
3
Please make sure the Walker is fully opened, seat is
down and the folding bar under seat is locked in the
down position.
Be sure that both knobs are fully tightened and are
at equal heights. Test Rollator for stability before
applying full weight to hand grips.
Test the push down locks before operating the Walker.
When wheels are locked (by sitting or having weight
applied by pushing down on handles), rear wheels
should prevent wheels from turning. If the wheels
turn while locks are locked, please take unit back to
dealer for adjustment. When weight is released, the
wheels should turn freely.
Weight will lock push locks by sitting. Do not use seat
when unit is on an incline or uneven ground.
Replace tires when significantly worn or damaged.
Do not have anyone push you while you are seated on
the Walker. This is a walking aid only and is not to be
used as a transportation device.
Push Down
Lock Operation:
Always engage and disengage wheel locks on both sides
simultaneously.
To Slow Down or Come to a Temporary Stop —
Push down slowly by applying weight on the handles
until unit slows down or comes to a temporary stop.
To Temporarily Lock Wheels in Position —
Once seated, rear wheels will automatically lock until
weight is removed.
To Release Wheel Locks —
Remove weight until wheels start moving freely.