Drive Dr.K Go/Lite 10209RD-1 Installation instructions manual

Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards
and carefully inspected prior to shipment. This
Lifetime Limited Warranty is an expression of our
confidence in the materials and workmanship of
our products and our assurance to the consumer
of years of dependable service.
In the event of a defect covered by this warranty,
we will, at our option, repair or replace the device.
This warranty does not cover device failure due to
owner misuse or negligence, or normal wear and
tear. The warranty does not extend to non-durable
components, such as rubber accessories, casters,
and grips, which are subject to normal wear and
need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
Instructions & Warranty
www.drivemedical.com
For use with all 10209, 4 Wheel Push
Lock Go-Lite Rollators
Rollator
Rollator
LIFETIME LIMITED
WARRANTY
Shown
Item # 10209RD-1
Dr.K # X4200R
Port Washington, NY 11050
MADE IN CHINA
© 2002 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China

Assembly Instructions:
Safety Precautions:
Do not attempt to adjust or operate Rollator without
carefully reading all instructions in this maual.
First remove all contents from carton: backrest,
handle with tube, Rollator frame and basket.
Open Frame and slide padded backrest into frame
brackets making sure snap bottons protrude
through holes.
Unscrew tightening knob from handle and insert
handle tube into frame at desired height lining up
holes appropriately. Slide bolts through holes from
the inside and screw on tightening knob until secure.
1
2
3
Please make sure the Rollator is fully opened, seat is
down and the folding bar under seat is locked in the
down position.
Be sure that both knobs are fully tightened and are
at equal heights. Test Rollator for stability before
applying full weight to hand grips.
Test the push down locks before operating the
Rollator. When wheels are locked (by sitting or
having weight applied by pushing down on handles),
rear wheels should prevent wheels from turning. If
the wheels turn while locks are locked, please take
unit back to dealer for adjustment. When weight is
released, the wheels should turn freely.
Weight will lock push locks by sitting. Do not use seat
when unit is on an incline or uneven ground.
Replace tires when signi cantly worn or damaged.
Do not have anyone push you while you are seated on
the Rollator. This is a walking aid only and is not to
be used as a transportation device.
Push Down
Lock Operation:
Orthodic
Hand Grips
Height
Adjustable
Wide
Comfortable
Seat
Folding
Hinge for
Portability
Push Down Locks
Backrest
Hanging Basket
for Functionality
& Storage
Sealed Wheel
Bearing for
Smooth Operation
Item #10209
Push Down Lock Style
Always engage and disengage wheel locks on both sides
simultaneously.
To Slow Down or Come to a Temporary Stop —
Push down slowly by applying weight on the handles
until unit slows down or comes to a temporary stop.
To Temporarily Lock Wheels in Position —
Once seated, rear wheels will automatically lock until
weight is removed.
To Release Wheel Locks —
Remove weight until wheels start moving freely.
3
2
1