DXV 5004A User manual

INSTALLATION INSTRUCTIONS
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2017
SAVE FOR FUTURE USE
- 1 -
In the United States:
DXV
One Centennial Avenue
Piscataway, New Jersey 08855
Attention: Director of Customer Care
For residents of the United States, warranty
information may also be obtained by calling
the following toll free number: [phone]
www.DXV.com
In Canada:
DXV
5900 Avebury Road
Mississauga, Ontario
L5R 3M3
Canada
Toll Free: 1-800-387-0369
Local: 905-306-1093
Fax: [phone]
www.DXV.ca
In Mexico:
DXV
Via Morelos 330
Col. Santa Clara Coatitla
Ecatepec, Estado de México 55540
Toll Free: 01-800-8391200
www.DXV.mx
RECOMMENDED TOOLS AND MATERIALS
Most of the procedures require the use of common tools and materials, which are available from hardware and plumbing
supply stores. It is essential that the tools and materials be on hand before work is begun.
Thank you for selecting DXV. To ensure this product is installed properly,
please read these instructions carefully before you begin. (Certain in-
stallations may require professional help.) Also be sure your installation
conforms to local codes.
760168-100 Rev. B (6/17)
Elongated Models: 5004A, 5006A, 5011A
Round Front Model: 5004B
Slow Close Toilet Seats
Plumbers' Putty or Caulking
Phillips Screwdriver
Flat Blade Screwdriver
1
3
2
4
Hinge
Screw
Cap
Washer
Plug
Grommet
Bolt
Flange
Bulb Wet this area with water
For ease of installation of black rubber grommets,
insert steel bolt (capture a few threads), and wet the
lower area with some water (soapy water works best).
Insert plugs into
seat holes in bowl.
NOTE: FLANGE MUST REMAIN ABOVE THE SURFACE.
DO NOT ALLOW GROMMET TO FALL THROUGH!

- 2 - 760168-100 Rev. B (6/17)
5
7
9
6
8
10
A
B
REPLACEMENT KIT PART NUMBER
760215.100.XXX
DESCRIPTION
*Seat Hardware Kit
*Includes a set of seat bumpers and all hardware
needed for installation of seats.
Install rubber
washer into
hinge.
Snap hinges with washer
into holes on the bottom
of the seat.
Place the caps over the hinges.
Put screws into seat
hinge and tighten using
a screwdriver.
Place seat back on bowl
and click seat onto hinges.
Place seat with hinges onto bowl.
Align seat with front of bowl.
Open the seat and cover. Push both inside buttons
to release seat and cover. Pull the seat and cover
upwards to take it off the hinges.