Dynojet power commander III User manual

i210-411 2003 Kawasaki Z1000 - PCIII USB - 1
2003 Kawasaki Z1000
Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 [phone] www.powercommander.com
Parts List
1 Power Commander
1 USB Cable
1 CD-ROM
1 Installation Guide
1 Power Adapter
2 Power Commander Decals
2 Dynojet Decals
1 Velcro®Strip
1 Alcohol Swab
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
The ignition MUST be turned
OFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
USB Port
Expansion Port

1 Remove the main seat and the
passenger seat.
2 Remove the fuel tank
Note: The installation can be done
without removing the fuel tank
but it may be easier to remove
the fuel tank.
3 To remove the fuel line squeeze
the sides of the connector
(Fig. A). Disconnect the two
electrical connectors.
4 Lay the PCIII in the tail section
as shown in Fig. B temporarily.
5 Route the harness towards the
front of the bike. Keep the har-
ness between the frame and the
tail section.
6 Pull the L.H side of the tail
section out of the frame
grommet towards the front of
the tail section (Fig. C).
7 Route the PCIII harness under
the frame tab (Fig. C).
Fig. AFig. B
Fig. C
i210-411 www.powercommander.com 2003 Kawasaki Z1000 - PCIII USB - 2
Disconnect these lines
Frame tab
Squeeze this line to remove
PCIII harness
Grommet
PCIII harness

8 Route the ground wire from
the PCIII under the frame and
attach to the negative side of
the battery (Fig. D).
9 Locate the stock throttle body
connector under the fuel tank
(Fig. E).
10 Pull straight upwards on this
connector to remove from its
frame post.
11 Pull the stock connector
underneath the frame.
12 Unplug the stock connector
(Fig. F).
Fig. DFig. E
Fig F
i210-411 www.powercommander.com 2003 Kawasaki Z1000 - PCIII USB - 3
Pull upwards to remove
PCIII harness
Ground wire
Stock connectors

13 Plug the PCIII harness in-line of
the stock connectors (Fig. G).
14 Make sure the PCIII harness is
routed so that it will not get
pinched or damaged.
15 Reinstall the fuel tank
16 Clean the PCIII unit and inner
fender with the supplied alcohol
swab.
17 Use the supplied velcro to attach
the PCIII to the inner fender
(Fig. H).
18 Reinstall the seats.
Fig. GFig. H
i210-411 www.powercommander.com 2003 Kawasaki Z1000 - PCIII USB - 4
Stock connectors
PCIII connectors