
4
GREEN MOTION BUILDING USER MANUAL MN191027EN December 2021 www.eaton.com
1. Introduction
Thank you for choosing the Green Motion Building electric vehicle (EV) charger.
Green Motion Building is an AC EV charger specically designed for use in private
and public parking facilities for multi-residential, light commercial and industrial
applications. It can be xed to the wall or on a oor-mounted column, either indoor or
outdoor.
Before you start
This manual contains important instructions that must be followed during the installation, operation and maintenance of the
Green Motion Building electric vehicle charger. All instructions must be read before installing and operating the equipment.
This manual should be retained for future reference.
Please note that the Green Motion Building EV charger must only be installed and maintained by professional and qualied
personnel, i.e., an Eaton technical support representative or professional installer. Professional and qualied personnel
must be expert in the eld and must therefore be responsible for commissioning the system in accordance with the
manufacturer’s instructions and ensure that all steps of the installation, operation and maintenance comply with local
legislation.
There are no user-serviceable parts inside the equipment. Failure to observe the above will void the provided product
guarantee and Eaton cannot be held legally accountable.
The contents of this manual are the copyright of Eaton and may not be copied, reproduced or redistributed in whole or in
part without Eaton’s prior written permission. While every care has been taken to ensure the accuracy of the information
contained in this manual, Eaton assumes no liability for any error or omission. Eaton reserves the right to modify the designs
of its products. The unauthorized copying and lending of this manual is prohibited.
Technical disclaimer
All drawings, descriptions or illustrations contained in this document serve to provide a clear overview and/or technical
explanation of the present product and its various components and accessories. In line with our goal to continuously
improve the products and the customer service we provide, all specications contained in this document are subject to
change without notice, as Eaton reserves the right to modify the designs of its products.
Legal entity
Eaton Industries Manufacturing GmbH
Address: Place de la Gare 2
1345 Le Lieu
SWITZERLAND
Web: www.eaton.com