Elite Screens CineTension B Series Guide

Rev. 03/28/17 1 www.elitescreens.com
Limit switch adjustment instructions for CineTension B Series
NOTE: Elite Screens does not recommend making unnecessary adjustments to the screen, as improper
adjustments will damage the unit and may void your warranty.
For safety reasons, never disassemble the limit switch.
The upper and lower limit switches are located in the right end of the screen housing when facing the screen.
Please refer to the fig. below to locate the upper and lower limit switches.
NOTE: When turning the limit switches, bear in mind that a full‐circle turn in either direction will create a one
inch adjustment.
A. If you over adjust the rise position, the screen will attempt to go further into the case and cause it jitter
and bounce.
B. If you over adjust the drop position, the screen will begin to reverse itself back up.
C. Reversing the adjustments should bring the screen back to normal operation
White = DROP
Yellow = RISE
The white limit switch is
accessed where the screen is
deployed.
The yellow limit switch can only
be accessed through the hole
located at the bottom right end
of the screen.

Rev. 03/28/17 2 www.elitescreens.com
How to adjust the Retract (rise) position:
If the screen does not retract completely, use the following steps.
1. Press the UP button on the remote first to retract the screen as much as possible.
2. Use the Allen‐wrench to turn the RISE (yellow) switch counter‐clockwise. When you turn the RISE
switch, the screen will retract correspondingly.
3. Stop rotating the switch once the weight bar is inside and in‐line with the opening.
Warning: If you continue to rotate the switch once the weight bar is in‐line with the opening, the screen
will attempt to retract further inside and causing permanent damage to the screen. DO NOT over turn the
switch.
4. If the screen retracts too far in, press the DOWN button on the remote to expose the limit switches.
Rotate the RISE adjustment switch 1‐2 turns clockwise. Then press the UP button on the remote to
see the new retract position.
How to adjust the Drop (top black masking border) position:
Note: All electric screens come with standard top black masking and they cannot be dropped further.
DO NOT use these instructions to try to get more out of your standard black masking drop. Use these
instructions only if you have decreased the amount of your black masking and need to increase it back.
If you need to decrease the amount of the top black masking, use the following steps.
1. Press the DOWN button on the remote first to fully deploy the screen.
2. Use the Allen‐wrench to turn the DROP (white) switch clockwise. When you turn the DROP
adjustment switch, the screen will raise.
3. Stop turning the switch once the screen reaches the desired position.
Warning: If you over‐turn the switch, the screen will raise too high, which may permanently damage the
product.
4. If the screen rises too high, simply turn the DROP adjustment switch counter‐clockwise. Press the
UP button on the remote first and then press DOWN to see the new drop position.
For more information, technical support or your local Elite Screens contact, please visit
www.elitescreens.com