Elo TouchSystems Z30POS Stand User manual

Revision B
P/N E236351
Assembly Guide
Z30POS Stand

Kit Contents
Z30 POS Stand (Qty 1)
150W DC Power Adapter and cables
M3x6mm screw for cable door (Qty 1)
M4x8mm screw for mounting plate (Qty 1)
M4x6mm at-head screw for display mounting (Qty 4)
Mounting bracket (Qty 1)
Tie-wraps (Qty 2)
USB-C (E483135 Only)
Cash Drawer
USB-A, x2
DC Power In
Powered USB
USB-A, x2
Ethernet

Elo Z30 POS Stand supports the I-Series 4 Slate display ordered separately. Remove screw on
cable lock bracket from the rear of the display and place screw and bracket aside for reinstallation
in step 6.
1
2
Power button
M3 Screws
bottom cover
M3 Screw
top cover
Remove the upper and lower VESA mount covers by removing the M3 screws noted below.

Install I-Series 4 Slate display on stand using included M4x6mm at-head screws.
3
4Mount the system to a table (optional). Skip to Step 6 if not mounting to a table.
Secure the mounting bracket to the table using appropriate screw type and length. Elo suggests M4
or #10 screw diameter.

6Secure the system to the bracket using the M4x8mm screw included in the accessory box.
5Lower the system onto the bracket and slide it back ensuring the bracket engages the screws on
the bottom side.

7Connect the USB-C cable located in the hinge of the stand to the I-Series 4 Slate display. Re-install
the cable lock bracket and screw from step 1.
8
M3 Screws
bottom cover
M3 Screw
top cover
Slide the upper VESA mount cover over the VESA mount bracket and install the M3x6mm screw
removed in step 2 to secure it in place. Install the lower VESA cover so it covers the USB-C cable
ensuring the cable routes freely. Install the M3x13mm screws removed in step 2 to secure the lower
VESA mount cover.

Route the DC power cable through the hole in the bottom of the stand and connect it as shown.
Connect other I/O cables as needed (see page 2) Make sure all cables route through the plastic
clip at the bottom and re-install cable cover door.
Clip
Power
10
9Remove the cable cover door to access the I/O connections.

© 2021 Elo Touch Solutions, Inc. All rights reserved.
The information in this document is subject to change without notice.Elo Touch Solutions,Inc.and its Affiliates (collectively “Elo”) makes no representations
or warranties with respect to the contents herein, and specifically disclaims any implied warranties of merchantability or fitness for a particular purpose.
Elo reserves the right to revise this publication and to make changes from time to time in the content hereof without obligation of Elo to notify any person
of such revisions or changes.
No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer
language, in any form or by any means, including, but not limited to, electronic, magnetic, optical, chemical, manual, or otherwise without prior written
permission of Elo Touch Solutions, Inc.
Elo and the Elo logo are either trademarks or registered trademarks of Elo Touch Solutions, Inc..
America
Tel [phone]
[email protected]
Europe (EMEA)
Tel [phone]
[email protected]
Asia Pacific
Tel [phone]
[email protected]
Learn more about Elo at EloTouch.com
11
Power
Button
Power on the system when installation is complete.