Under
UnderUnder
Undersea Volcanic Eruption!
sea Volcanic Eruption!sea Volcanic Eruption!
sea Volcanic Eruption!
Activate your capability switch and red lava beads continuously erupt
from the volcano to create a wonderful visual display. Soft lights
enhance the eruptions. Great to increase visual attention.
Size: 5½"H x 3"D. Requires 4 AA Batteries.
Operation:
Operation:Operation:
Operation:
1. Nature’s Fire requires 4 AA batteries. Use alkaline batteries only
(e.g. Duracell or Energizer brand . Do not use rechargeable, heavy-
duty or any other type of batteries because they supply lower
voltage and the unit will not perform properly. Never mix old and
new batteries together or different brands or types together.
Follow the installation diagram below.
2. Follow filling and tank setup diagram:
3. Next plug in your external capability switch into the female 1/8"
jack, located in the side of the Nature’s Fire. If your switch has a
¼" male plug, then order one of our #1170 ¼" to 1/8" adapters.
Make sure the male plug is pressed firmly into the female jack,
there should be not gaps. Set the Nature’s Fire’s ON/OFF
ON/OFFON/OFF
ON/OFF switch
for the Lava (located next to the switch jack to OFF
OFFOFF
OFF. You can now
activate the flowing Lava with your switch.
4. When you activate your switch the Lava will flow. Once you release
your switch the Lava will stop.
5. Please Note: The red light is not controlled by your switch, only the
Lava will be.
6. The Nature’s Fire can be used normally without the use of a
switch.
Troubleshooting:
Troubleshooting:Troubleshooting:
Troubleshooting:
Problem:
Problem:Problem:
Problem: The Nature’s Fire does not turn on when switch is
depressed.
Action #1:
Action #1:Action #1:
Action #1: Make sure that you press all connections firmly together.
Any gaps may interrupt electrical connection. The Lava’s ON/OFF
ON/OFFON/OFF
ON/OFF
switch needs to be set to O
OO
OFF
FFFF
FF
for external switch use.
Action #2:
Action #2:Action #2:
Action #2: Make sure batteries are fresh.
Action #3:
Action #3:Action #3:
Action #3: Try a different switch with your Nature’s Fire to rule it out
as the source of the problem.
Care of Unit:
Care of Unit:Care of Unit:
Care of Unit:
The Nature’s Fire can be wiped clean with any mild household multi-
purpose, non-abrasive cleaner and disinfectant. We recommend
Simple Green, which is a non toxic biodegradable all-purpose cleaner.
Do not submerge
Do not submergeDo not submerge
Do not submerge the unit in any fluids, as it will damage the contents
and the electrical components.
Do not use abrasive cleaners
Do not use abrasive cleanersDo not use abrasive cleaners
Do not use abrasive cleaners, as they will scratch the surface of the
unit.
Rev
Rev Rev
Rev 5/2
5/25/2
5/2/1
/1/1
/17
77
7
