Enabling Devices Spinning Light Show User manual

For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-TEC-TOYS or 1-800-832-8697
custom[email protected]
Spinning Light Show #145
USER’S GUIDE
385 Warburton Avenue
Hastings-on-Hudson, NY 10706
Tel. [phone] / Fax [phone]
www.enablingdevices.com

This dome features a multi-colored array of lights that create an exciting
show. Great for children who require extra somatosensory stimuli. Size:
6½"L x 7½"W x 4½"H. Requires a Capability Switch and 2 AA Batteries.
Operation:
1. The Spinning light show requires two AA batteries (not included).
Use alkaline batteries only (e.g. Duracell or Energizer brand). Do
not use rechargeable batteries or any other type of batteries
because they supply lower voltage and the unit will not perform
properly. Never mix old and new batteries together or different
brands or types together.
2. The battery compartment is located under the base of the unit.
Carefully turn the unit over, and then remove the battery cover
with a small Phillips Head screwdriver. Install new batteries, being
careful to observe proper battery polarity.
3. Connect any capability switch via the 1/8 inch jack on the side of
the unit. Make sure your connection is tight, there should be no
gaps. Activate your switch and you will be rewarded with spinning
lights. Release pressure from your switch and the lights will stop.
Troubleshooting:
Problem: The Spinning light show does not spin or light up.
Action # 1: Check all Batteries for strength and for proper battery polarity.
Replace if weak or dead. Rotate (spin) the batteries within the battery
compartment to ensure a good connection.
Action # 2: Make sure all connections are tight.
Action # 3: Check your switch with another device you know works or try
another switch to rule out the Spinning light as the source of the problem.
Action # 4: If adapters are being used, they must be Mono only stereo
adapters will not work.
Care of the Unit:
The Spinning Light Show can be wiped clean with any mild household
multi-purpose, non-abrasive cleaner and disinfectant. We recommend
Simple Green, which is a non toxic biodegradable all-purpose cleaner.
Do not use abrasive cleaners, as they will scratch the surface of the
unit.
Do not submerge the unit, as it will damage the electrical
components.
Rev 2/13/08