Englefield VALENCIA ELITE User manual

1393318-A02-A July 2019
INSTALLATION
INSTRUCTIONS
SHOWER
VALENCIA ELITE Angle Corner Pivot
Englefield has a history
of making superb showers
and their popularity is
testament to their quality
and affordability.
It’s the details that Englefield
cares about - from pioneer-
ing the latest technology, to
innovative design, it’s all to
make your showering
experience the very best it
can be.
Note: Tapware and accessories not included.

Page 1
Before installing the shower please read these instructions carefully to familiarise
yourself with the required tools, materials and installation sequences. Please leave these
instructions for the consumer after installation. Refer to the separate care and maintenance
guide for important care and cleaning information.
Ensure that the shower tray and wall, if applicable, are completely finished prior to
installing your shower door and return. Follow all warnings, cautions and instructions
contained in this guide.
1. ENGLEFIELD strongly recommends that a minimum of TWO persons install this
enclosure due to the weight of the door panels.
2. Toughened safety glass cannot be cut. Risk of injury or product damage.
3. Wear protective footwear when lifting panels.
4. Wear safety glasses when drilling.
1. The wall retainers must be installed onto a waterproof, vertical and flat wall surface.
Failure to do so will result in an unsatisfactory seal, which may cause property damage.
The wall inclination (out of squareness) is recommended to be out by no more than
+/- 4mm/m.
2. Please install this door onto an ENGLEFIELD Quick - Fit shower tray only, unless
installing directly onto tiled walls and floor.
®
3. Care must be taken when drilling into walls and floors to avoid any hidden pipes or
wires.
4. It is the responsibility of the INSTALLER to ensure that the installation complies with
council and or local authority bylaws.
INSTALLATION INSTRUCTIONSVALENCIA ELITE Angle Corner Pivot
BEFORE YOU BEGIN
SAFETY
!
!ATTENTION
Instructions, drawings, and diagrams contained in this manual present information available at the time of printing.
changes without further notice.
ENGLEFIELD

Page 2
INSTALLATION INSTRUCTIONS
ENGLEFIELD
VALENCIA ELITE Angle Corner Pivot
!
ATTENTION
Short section of drip
strip may be packed
with different seals.
Do not discard.
1 x Door
2 x Corner Post
Screw Covers
2 x Corner
Covers
2 x Wall Edge
Finishing Strips
1 x Seal Pack
2 x Wall Channels
2 x Return Panels

Page 3
INSTALLATION INSTRUCTIONS
ENGLEFIELD
VALENCIA ELITE Angle Corner Pivot
1 x Fittings Kit
1 x Handle Kit

Handle Assembly

66x Cover Caps

8x Fixing Screws

Hex Key


8x Wall Plugs
1x Hex Key
3mm
16x ST4*12 Screws

A

2025mm
Minimum
Height
CONSTRUCTION REQUIREMENTS
Due to the weight of the glass panels Englefield strongly recommends
constructing double studs (as below) to fix the wall retainers to.
!ATTENTION
Page 4
INSTALLATION INSTRUCTIONS
A
Double
studs
Double
studs
B
ENGLEFIELD
VALENCIA ELITE
Size Dim ‘A’
900 x 900 900
1000 x 1000 1000
Dim ‘B’
900
1000
Angle Corner Pivot

Tray: For tray installation refer to the instructions supplied with the tray.
Wall: For wall installation refer to the instructions supplied with the wall.
- Proceed to Door and Return Installation.
- The door and return can be installed directly onto the wall and floor tiles.
- Proceed to Door and Return Installation.
OPTION 1 - Acrylic Wall & Tray
OPTION 2 - Tiled Wall & Acrylic Tray
Page 5
INSTALLATION INSTRUCTIONS
OPTION 3 - Tiled Wall & Floor
ENGLEFIELD
INSTALLATION - Options
Tray: For tray installation please refer to the instructions supplied with the tray.
Wall:
- The vertical wall retainers MUST be installed onto the waterproof membrane PRIOR TO
WALL TILING. If possible the complete door system should be installed onto the
waterproof membrane prior to wall tiling.
CAUTION: Failure to install the wall retainers first may
mean the door system may not fit on the shower tray
due to the tile thickness.
- If not installing the complete door system prior to tiling,
install the wall retainers and tiles. The retainer cover
extrusion can be inserted after tiling - there is no need
to leave a tiling gap. Refer to image.
- Proceed to Door and return installation.
Tile up to
retainer
VALENCIA ELITE Angle Corner Pivot

Caution: Ensure tray or tiled floor is
level & walls are vertical & square.
For tray base option:
- Mark 15mm in from top edge of tray.
For tiled base option:
- Mark from finished wall to outer edge
of retainer.
Tip: Cover the waste to prevent the loss of
small parts. If installing onto a tray protect
the tray surface during installation.
Page 5
15 mm
15 mm
Page 6
INSTALLATION INSTRUCTIONS
ENGLEFIELD
INSTALLATION
1
B
A
(a) Mark the locations of the wall retainers.
VALENCIA ELITE
900 x 900
1000 x 1000 863 863 970 970
ASize B
± 0 mm ± 0 mm
Angle Corner Pivot

± 0 mm
3 mm x4
15 mm
x4
(a) Position the wall channels on the wall. The flange with pre-drilled holes should face
inside the shower enclosure. Using a level, make sure that the channel is upright.
Mark the position of the fixing holes down the centre of the channel, then remove
the channel.
Drill with a 3mm bit. For other types of wall structure, alternative fixings may be
required (not supplied).
(b)
(c)
Apply silicone sealant along the length of the wall and at the bottom where the wall
channel will be placed, including the top of the tray.
(d)
Position the wall channels on the wall and install the fixing screws .
(e)
Fully tighten the fixing screws, making sure that the wall channels are upright.
(f)
Repeat the process for the other wall channel.
(g)
A
Page 7
INSTALLATION INSTRUCTIONSVALENCIA ELITE
ENGLEFIELD
Angle Corner Pivot
2
A

Page 8
INSTALLATION INSTRUCTIONS
ENGLEFIELD
(a)
(b)
Insert the return panels into the wall channels, ensuring that the aluminium strip is
at the bottom of the glass.
Carefully rotate the door frame so that it is in the desired orientation.
VALENCIA ELITE
3
Angle Corner Pivot

Page 9
INSTALLATION INSTRUCTIONS
ENGLEFIELD
4
(b) Adjust the panels so that the door magnetic seals sit correctly and the gap between
the door glass and horizontal rails is equal.
(a) Lift the door frame into position and insert into the 45° corner posts of return panels.
VALENCIA ELITE
A
B
=
=
Angle Corner Pivot

Page 10
5
±
Angle Corner Pivot
Centralise the door frame within the corner posts, ensuring the door frame is square.
From the inside of the enclosure drill four holes in each of the four posts, through
the centre-marked points in the aluminium with a 3mm HSS drill (not supplied).
Install and tighten the assembly screws .
Ensure the corner post screw cover clips are in place and insert the cover strips.
Fit the corner covers to the wall channels. They should “snap” into place.
x16
x16
(a)
(b)
(c)
(d)
(e)

Page 11
Install the vertical and horizontal door seals onto the door panel.(a)
Install the door handle, ensuring that the grub screws are on the underside.(b)
Fit the caps to the top of the posts. Add silicone or modify caps to fit if required.(c)
Drip Strip
Drip Strip
Angle Corner Pivot

Page 12
200mm up
200mm up
Full length Full length
Full length
(a)
(b)
(c)
Angle Corner Pivot

Handle Assembly
1365840-**
Wall Finishing Strip
1315530-**
Wall Retainer
1278347-**
Retainer Cover Clip
1278349
Retainer Cover
1278348-**
Pivot Hinge
1365838-**
Cover Clip
1393420
Mag Strip Pair
1365842
Component Kit
1393422-**
Horizontal seal
1365844
Pivot Block
1365839-** Corner Post Cover Strip
1393421-**
Return Panel (900)
1393418-**
Return Panel (1000)
1393428-**
Door Seal
1365843
Bottom Strip (900)
1393419-**
Bottom Strip (1000)
1393429-**
CONTACT AND WARRANTY INFORMATION
NEW ZEALAND
KOHLER NZ LTD
Free Ph: 0800 100 382
Free Fax: [phone]
www.englefield.co.nz
AUSTRALIA
KOHLER AUSTRALIA
Free Ph: 1 800 ENGLEFIELD
(1 800 364 533)
www.englefield.com
Engleeld
INSTALLATION INSTRUCTIONS
CLEANING AND MAINTENANCE INSTRUCTIONS
Please refer to our website for cleaning instructions.
For warranty information, please visit our website.
VALENCIA ELITE Angle Corner Pivot
Scan the QR barcode on the packaging or underside of top caps to identify the product SKU and date of manufacture.
!