Englefield 1830 User manual

V087040-G October 07 Kohler Co.
With a soft pencil, mark join
between top cap and Shower-
Tower post. (Take care not to scratch
surface of shower wall.
2
When fitting to a duracryl surround the shower tower must be installed immediately following installation of the
wall, and before adhesive cures. this will ensure an even line between the shower tower and the surround.
From mark, measure down and
mark centre lines for clips.
3
For Shower Tower 1000 mark top two
centre lines only! Do not mark bottom
two centre lines
Align holes in clips with centre
lines and mark hole centres.
Ensure clip is firmly in corner.
4
Drill holes into wooden studs
with a 3mm drill bit. ( Use a
suitable masonry drill bit and suit-
able screw anchors for tiles. Use a
suitable cavity fixing where wooden
studs are located.
5
IMPORTANT
ONLY DRILL 4 HOLES FOR SHOWER
TOWER 1000
Position shower tower in corner.
1
INSTALLATION GUIDE
SHOWER TOWER 1830 & 1000

V087040-G October 07 Kohler Co.
NEW ZEALAND
KOHLER NZ Ltd.
133 Diana Drive,
Glenfield,
Auckland.
Ph [phone]
Fax [phone]
[e-mail]
www.kohler.co.nz
Then rotate bracket 90deg to
engage small pin at bottom
end of bracket in small hole.
Repeat for all brackets.
11
Align hoops with mounting
brackets, push down and
click into position. Press fit 2 soap
dishes & 2 top hoops.
12
Fit top end of Tee into
horizontal slot in the tower.
10
CALL US FOR HELP
AUSTRALIA
KOHLER Co.
Unit 10, 70-99 St. Hilliers Road,
Auburn,
Sydney. NSW 2144.
Ph [phone]
Fax [phone]
[e-mail]
www.kohler.co.nz
Hold plastic mounting bracket
as shown.
9
Position Tower in corner and
engage clips along length ensur-
ing all clips are inside the extrusion.
7
Holding the bottom fast with
foot, secure the top clip using
a sharp jolt with the palm of your
hand. Continue down to the bottom
of the Tower.
8
Shower Tower Spring clip
Wall lining
Fix clips to wall using screws
supplied. Seal screw heads
with silicone
6