Enwork Wall Mounted Tapered Credenza User manual

Wall Mounted Tapered Credenza
EI0007 –Rev A
Wall Mounted Credenzas
Installation Instructions

1) Parts and Fasteners Included
INSTALLATION GUIDE
WML20xxAx
WMLB20xxAx LZCEET30 #10-1.25 Phillips Flat
Head Screw
***NOTE: Dealer/Installer must determine wall construction and
provide appropriate wall anchors to secure LZCLEET brackets

2) Tools and Supplies Required
INSTALLATION GUIDE
Drill Level Phillips Bit
Tape Measure

3) Assembly Overview
INSTALLATION GUIDE
Fig 3.1
Before Beginning Installation:
- Number of people required for assembly: 2
- The architectural wall must be able to support 100 pounds of weight per
linear foot of credenza. (i.e. – 6’ Credenza = 600 pounds of support)
- Determine wall construction and use appropriate wall anchors to secure
LZCLEET brackets to wall.
- Read all instructions prior to beginning installation
3.1.1) Attach LZCLEET brackets to back of credenza
using #10 x 1.25” Wood Screws as shown in Fig 3.1.
***Note: See detail for bracket orientation***

3) Assembly Overview
INSTALLATION GUIDE
Continued
Fig 3.2
3.2.1) Install LZCEET brackets to wall. For a
wall mounted tapered credenza with a top
height of 31”, your bottom LZCLEET
bracket should measure 16.3” from the
floor to the center of the mounting hole.
3.2.2) Secure bottom LZCLEET bracket to
the wall, ensuring that it is level.
3.2.3) Locate and install the upper LZCLEET
brackets to wall. (Refer to Credenza
bracket spacing page for dimensions)
3.2.4) Place the credenza onto the
LZCLEET brackets.
***Note: For Buffet Height, Refer to Fig 3.3
on the next page***
***Note: If the wall is not plumb, it will
make it difficult to engage the LZCLEET
brackets. It may be necessary to shim the
Z-brackets on the wall.