Enwork AMBITION User manual

Ambition 24”H Topper Screens Installation Instructions – Rev A.
AMBITION 24”H TOPPER SCREEN
INSTALLATION GUIDE
SCREENS
AMI0008

INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
Screen
#10 x 3/4” Self-Drilling Screws
10-32 x 1/8” Set Screw
PNM-1954 Brackets 10-24 Binding Bolt Pair
Gasket EM-1919

INSTALLATION GUIDE
2) TOOLS AND SUPPLIES REQUIRED
Drill/Driver Phillips Bit Hex Bit

INSTALLATION GUIDE
Sandwich the screen between the brackets using
the Binding Bolts.
Quarter Inch Thick Materials: Slide the gasket onto
the bottom of the screen and slide the assembly
into the slot on the beam top cap. If the t is too
snug, use soapy water to slide easier.
Half Inch Thick Materials: Center the screen on the
top cap front to back and left to right.
Once the screen is rmly in place use the self-
drilling screws to rmly attach the brackets to the
beam top cap.
FIGURE 1
FIGURE 2
FIGURE 3
3) ASSEMBLY:

INSTALLATION GUIDE
In cases where multiple screens are next to
each other EM-1919 brackets and the 10-32 Set
Screws may be included to connect the screens
together at the seams.
FIGURE 4
3) ASSEMBLY CONT.

Specications subject to change without notice.
Rev 08.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331