Enwork Sawhorse User manual

Sawhorse
CONFERENCE TABLES
TI0001
Sawhorse Conference Table Installation Guide – Rev 11.14.22

2
1 – Included Parts and Fasteners
Sawhorse Legs #10 x 1” Panhead Phillips Tight Joint Multi Piece Work
Surface
2 – Tools and Supplies Required
Drill Square Driver Bit 5mm Allen Wrench

3
Lay tops face down on a non marring surface.
Flip the assembly upright and place the table in it’s
desired location.
Attach 4 Saw Horse Legs to 1 of the work surfaces
using the leg predrilled holes and the provided #10 x 1”
screws.
Note: the leg plates will overhang the work surface
edge.
1
3
2
3 – Assembly: Sawhorse Leg Installation (multi-piece)
Figure 3.1
Figure 3.3
Figure 3.2

4
5. Align the preassembled tops into position.
Repeat steps 2 & 3 to all top pieces.
Install tight joint connectors, assuring all surfaces are
aligned and tight . Attach the Saw Horse Legs to the
work surfaces using the predrilled holes and the
provided #10 x 1” screws.
5
4
6
3 – Assembly: Sawhorse Leg Installation (multi-piece)
Figure 3.4
Figure 3.6
Figure 3.5

5
Alternative leg position (optional)
To add stability, maximizes leg clearance or change
the table look, the outer legs may be mounted at a
splayed 45 angle no more then 72in apart.
Assembly complete
7
8
3 – Assembly: Sawhorse Leg Installation (multi-piece)
Figure 3.7
Figure 3.8

1.800.815.7251
enwork.com
12900 Christopher Dr. Lowell, MI 49331
Specications subject to change without notice.
Rev 11.14.2022