Enwork Overhead Storage Manual

Overhead Storage Assembly Procedure
Rev 0315

STEP1:
ATTACH THE SUPPORT BRACKETS TO THE GRID FRAME (4) SCREWS AND (4) NUTS AS
SHOWN (Figure 1). ATTACH (4) SUPPORT BRACKETS AS INDICATED BUT DO NOT
COMPLETELY TIGHTEN FASTENERS (SEE Figure 2)
Figure 1
(4) 10-24 X ½” Pan Head
Phillips Screw & (4) Nuts

STEP 2:
CENTER OVERHEAD CABINET ON GRID FRAME, OVERHEAD CABINET SHOULD BE RESTING
ON THE GRID FRAME AS INDICATED IN FIGURE 2. INSTALL (8) ¼-20 X ½” PAN HEAD PHILLIPS
HEAD SCREWS TO SECURE CABINET TO SUPPORT BRACKETS. TIGHTEN SECURELY.
Figure 2
CABINET SHOULD SET ON TOP
OF GRID FRAME
¼-20 X ½” PAN HEAD
PHILLIPS SCREWS

STEP 3:
MAKE SURE SUPPORT BRACKET LOWER MOUNTING PLATES ARE POSITIONED WITH THE
FASTENERS AND NUTS IN THE SLOTS AS INDICATED, (See Figure 3) TIGHTEN FASTENERS
SECURELY.
Figure 3
NUTS TO BE POSITIONED
INSIDE SLOT AS SHOWN