Enwork Multi-Piece Conference Top User manual

Multi-Piece Conference Top
Installation
Multi-Piece Conference Top Installation REV-A
Seam Leveling Guide

INSTALLATION GUIDE
Figure 1.1
Figure 1.2
Figure 1.3
•First, before installing a conference top, verify that
the table base is level. Please refer to the specific
table base instructions for your unit on how to
properly level the base. An Equilibrium table is
shown for reference.
•Verify how many tight joints are on the conference
top. Standard tops 36”-48”D have (4) tight joints
per seam, and 54” – 72”D tops have (6) tight joints
per seam.
•Place the top on the base.
•Install all of the tight joints lightly, without
tightening down on them.
•The top may need to be adjusted back and forth to
be able to reach all of the tight joints.
•Note: Do not attach tight joint fasteners with the
table top upside down and then flip the top onto
the base as the table seams may shift during
flipping.
2

INSTALLATION GUIDE
Figure 1.4
Figure 1.5
Figure 1.6
•Visually check the seam between the conference
top pieces. If the seam is not aligned, first check if
each piece of the top is level.
•Adjust the table base per the table base specific
instructions as needed to level the top.
•If the surface is level and the seam does not align
between pieces, lightly push and pull on two pieces
of the conference top as shown in Figure 1.5 to
align the seam. Once the seam is in the correct
position, tighten down the tight joint closest to that
edge of the table with a ratchet. This step will
require 2 people, one to hold the table in place, and
one to tighten the tight joint connector.
•Attach the conference top to the table base. If the
top has embedded braces, verify that none of the
screw heads interfere with the table base.
•If some screw heads do interfere with the table
base, remove those screws as necessary.
•Repeat these steps for each table seam, on both
sides of top.
3
12900 Christopher Drive Lowell, MI 49331
800.815.7251 www.enwork.com
Specifications subject to change without notice.