Enwork CONCURRENCE User manual

11/06/19 – Rev B.
CONCURRENCE CONFERENCE
TABLE INSTALLATION GUIDE
CONFERENCE TABLES
TI0001

INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
1⁄4-20 x .75 Flathead Phillips
LZYPLATE
Beam
1⁄4-20x .5 Panhead Phillips
Flag Bracket
End Base
#10 – 1 Panhead Phillips
Tite Joint
Mid Base – Optional

INSTALLATION GUIDE
2) TOOLS AND SUPPLIES REQUIRED
Drill Phillips Driver Bit Square Driver Bit

INSTALLATION GUIDE
3) ASSEMBLY: CONCURRENCE
Table width will determine the number of required
components (End Bases, Middle Bases and Beam
Assembly (Fig 1)). Middle Bases may not be required
for all builds.
Assembly of all bases will be identical, regardless of
table width.
Included in your parts should be the beam assembly
shown in Figure 2. Each table uses two Beams.
Depending on the table width, the Beam may be in two
pieces for shipping purposes.
The black Flag Brackets and silver LZYPLATE Brackets
should be preassembled to the beam for you. If
necessary, loosen the hardware, adjust location, and
re-tighten.
See Figure 3 for attaching the beam to the Bases.
Assemble the Beam Assembly into the Base
Assembly. The Flag Bracket will slot into the black
steel tube in the Bases. The supplied panhead bolts
go through the tube and thread into the Flag Bracket.
Tighten all of these bolts on both Beams rst.
FIGURE 1: TABLE BASES AS SHIPPED
FIGURE 2: BEAM ASSEMBLY ADDED
FIGURE 3: BEAM TO BASE CONNECTION
LZYPLATE
PANHEAD
BOLTS

INSTALLATION GUIDE
3) ASSEMBLY: CONCURRENCE CONT.
Once all the panhead bolts have been tightened the
table should look like Figure 4.
The next step of installation is shown in Figure
5 with the athead bolts passing through the
LZYPLATE and into the Bases.
Some adjustment of the LZYPLATE location might
be necessary.
Once the LZYPLATE have all been bolted into the
Bases the Top may be placed on the assembled Base.
Use the #10 screws provided to attach the Top to the
Base through the LZYPLATEs.
Depending on the width of the table the Top may be
in multiple pieces for shipping purposes. Tite-Joint
connectors are provided for attaching the Top pieces
to each other.
FIGURE 4: BOTH BEAMS INSTALLED
FIGURE 5: TOP PLATE FINAL INSTALLATION
FIGURE 6: FINISHED TABLE
F L A T H E A D
BOLTS

Specications subject to change without notice.
Rev 02.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331