Enwork eBench Table User manual

eBench Single Sided Installation Instructions – Rev A
eBENCH – SINGLE SIDED
ASSEMBLY INSTRUCTIONS
OPEN PLAN BENCHING
EI0008

INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
M8-1.25 x 40mm Socket Head
EBF6
EBSL
#10 – Panhead Phillips
EBEE
EBT
EBF1#8 x 0.625 Flathead Phillips EBF2
M6-1.0 x 30mm Tri Lobe Bolt
EBF3
EBDD
M8-1.25 x 45mm Flathead Bolt
EBRAIL
EBCB

INSTALLATION GUIDE
2) TOOLS AND SUPPLIES REQUIRED
3) ASSEMBLY: SINGLE SIDED EBENCH
Screwdriver
Assemble the End Leg and to the EBF6’s
with the provided Tri Lobe Bolts. Two EBFGs
should go on each End Leg.
Allen Driver BitsSquare Driver Bit Phillips Driver Bit
FIGURE 1

INSTALLATION GUIDE
3) ASSEMBLY: SINGLE SIDED EBENCH CONT. 1
FIGURE 2
FIGURE 4
FIGURE 3
FIGURE 5
Insert the EBF3 into the EBCB and slide them onto the EBEE. The EBF1 and
EBF2 serve as the washers on the outside of the EBDD. The M8-1.25 x 40mm
Sockethead bolt goes through the EBF1, the EBEE, the EBDD and then the EBF2.
Once all the bolts are installed the table should look like Figure 5.
Assemble the Mid Leg by attaching the EBSL
to the two EBDD’s using the M8 Flathead bolts.
Attach the EBF6’s to both sides with the provided
Tri Lobe Bolts.
In the same order as Figure 3, attach the Mid Leg
to the EBCB’s.

INSTALLATION GUIDE
3) ASSEMBLY: SINGLE SIDED EBENCH CONT. 2
Continue to use the same method and install all the legs to nish the table base.
Hang the troughs in the back from the rear EBF3 hooks. Install the EBRAIL’s to the tops in the predrilled
locations.
Slot the brackets into the EBF3 parts so that the tops can slide on the EBRAIL’s and EBF3’s.
FIGURE 6
FIGURE 7
FIGURE 9
FIGURE 8

Specications subject to change without notice.
Rev 02.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331