Epilog Laser Fusion User manual

www.epiloglaser.com
[e-mail]
303-215-9171
Y-Axis Home Switch Replacement
Fusion Maker - Fusion Edge - Fusion Pro 24 & 36
Parts Required Tools/ Materials Required
• LC0047 - Switch, Y-Home, Roller Lever • 5/32” Allen Wrench
• Phillips Head Screwdriver
.
01/2023

17000 - Y-Axis Home Switch Replacement
2
Y-Axis Home Switch
Replacement
Y-Axis Home Switch Removal
1. Turn o the engraver.
2. Disconnect engraver from power.
3. Remove the le or right panel of the
engraver, depending on which y-axis
home sensor is being replaced.
4. Manually move the x-axis assembly to
the middle of the engraver:
5. Locate the y-axis home sensor at the
rear of the y-axis assembly:
6. Disconnect the two (2) electrical
connections on the y-axis home switch:
7. Loosen and remove the two (2) Phillips
screw that secure the y-axis home
switch to the chassis of the engraver
and remove the y-axis home switch:

17000 - Y-Axis Home Switch Replacement
3
Y-Axis Home Switch Installation
1. Connect the two (2) electrical
connections on the y-axis home switch:
2. Position the y-axis home sensor over
the mounting holes on the chassis of
the engraver. Install and tighten the two
(2) Phillips screws that secure it to the
chassis of the engraver:
3. Replace the side panel of the engraver.
If further assistance is required, please
contact Epilog Laser Technical Support by
phone at 303-215-9171, or by email at
[e-mail].

17000 - Y-Axis Home Switch Replacement
4

17000 - Y-Axis Home Switch Replacement
5

17000 - Y-Axis Home Switch Replacement
6

17000 - Y-Axis Home Switch Replacement
7

17000 - Y-Axis Home Switch Replacement
8

17000 - Y-Axis Home Switch Replacement
9

17000 - Y-Axis Home Switch Replacement
10