Escea DX1500 Manual

DX1500 Information Sheet for Builders and Architects
Gas Specications
Heat Output 10kW*
Gas Input / Consumption 40MJ/hr*
Gas Connection Lower right side of appliance, 1/2”BSP
Gas Type Natural Gas / LPG (NZ) / Propane (Aus)
Operating Pressure 0.84kPa NG / 2.2kPa LPG or Propane
Inlet Gas Pressure 1.2kPa to 5.0kPa NG
2.5kPa to 5.0kPa LPG or Propane
Power Requirement 3 pin earthed 230V power outlet to
be within 1.0m of right side of the
appliance
Product Dimensions
* Internal results pending conrmation from test laboratory
Appliance Information
For further information or specications, visit the technical
section of our website www.escea.com to view the latest
product Installation Manual.
Cavity Information
61
183
914
744
1828
382
70
372
1900
MIN
800
MIN
450
MIN
381
Front Side
Single Sided
Side
Double Sided
150 MIN
1150 MIN
400 MIN
Minimum Cavity Dimensions (mm):
The appliance must be installed prior
to and behind the nished wall surface.
Take into account any plaster board, tiles
or any other nishing surface that may
be intended for the nished wall surface.
Wall nishing materials must not en-
croach upon the minimum cavity
clearances shown.
The wall board that lines the outside
of the opening can be normal plaster
board and does not need to be non-
combustible.
800
MIN
Mantle Clearances (mm) ‘Hutch’style cavity minimum dimensions (mm) Wall opening size for frameless / no fascia (mm)
630210_2
360
1560
SideFront
360

Cavity Size for Horizontal Powerue:
When cutting the hole in the outside wall, be mindful of how the installation
Horizontal Powerue Wall Terminal will be nished, the installation must be
weatherproof.
Ideal hole/cavity size for Horizontal Powerue
X 298mm
Y 298mm
Z 175mm
* Note, Z dimension does not include allowance for ue which exists here
as shown in the above diagrams. If the ue is exiting the powerue and im-
mediately going downwards, Z dimension will need to be at least 400mm to
allow for the ue and ue bend radius.
Flue and Duct Information
10m MAX
X
Y
X + Y = 12m MAX
= 0.6m MIN
FAN
FIRE
6m Ø250
6m Ø150
6m Ø150
FAN
FIRE
6m Ø150
6m Ø250 6m Ø150
FAN
FIRE
6m Ø250
6m Ø150
6m Ø150
Ducting information:
This gas re features a small network of ducting situated
either in the ceiling or under the oor to distribute the heat
generated by this replace. The maximum congurations for
this ducting network are shown below and the diameters in
mm.
Exhaust
Intake Air
Warm room air ducted to outlets
Flue information:
There are two basic types of ue conguration, using a
vertical powerue cowl, or a horizontal powerue cowl. The
horizontal oset of the terminal can be any amount up to the
total ue length shown. You cannot ue down, ie allow the
terminal to be lower than the outlet on the appliance.
(Standard duct kit)
630210_1