Factoryfurniture Bloc Concrete Bench Manual

factoryfurniture.co.uk
Bloc Concrete Bench
OPERATION & MAINTENANCE MANUAL

factoryfurniture.co.uk
Introduction
Design
Design, shop drawings and development by
Factory Furniture Ltd.
Manufacture
Factory Furniture manufactured components. Products
are assembled in Factory workshops, checked and
dispatched ready for installation. Replacement products
or components thereof should be ordered direct from
Factory Furniture Ltd.
Copyright
The design copyright for the product and
drawing copyright remains the sole property
of Factory Furniture Ltd.
General Specifications
Bench
Metric length 2000mm | width 500mm | height 450mm
Imperial length 6’ 6½” | width 1’ 7½” | height 1’ 5½”
Approx Weight 360kg
Fixing Centres 1900mm (6’ 3”)
Detailed Material & Finish
Specifications
Bench
• Seat material - Smooth or exposed aggregate
concrete. A variety of stone eects are available
in either smooth, shot peened, honed or polished
finishes. (Please refer to ‘Concrete Finishes’
specification document for further details).
Surface is smoothed and sealed to make it
water repellant
• Internal reinforcement - Stainless steel frame
General Maintenance
(Recommended Schedule & Guidelines)
Daily/Weekly/Monthly (or as adopted)
Visual checks of bench - check for superficial
or physical damage.
Three Monthly
Clean bench as detailed below
Six Monthly
Full clean as detailed below; check that bench is firmly
secured to the ground
Specific Maintenance Details
Concrete
Clean with a sti brush once per year, especially in
more exposed locations, in order to prevent a verdigris
type build up on the surface. Ideally, this should be
completed in early spring.
Repairs
Heavy Damage
In the event of serious damage please contact Factory
Furniture for detailed technical advice.
Reordering / Spares
There are no spare parts for this model of bench
AutoCAD Drawing List
FF1000 / 01
BLOC (Concrete)
GENERAL ARRANGEMENT DRAWING
FF1000 / 02
BLOC (Concrete)
SETTING OUT DRAWING

factoryfurniture.co.uk
Installation Instructions
All installation works to be carried out by competent
personnel - install as complete unit.
Bloc Bench (Concrete)
(surface or sub-surface fix)
1. Install suitable foundation pads (see illustration)
each with top face at ground level
2. Position bench in correct orientation with bases
centrally on foundation pads.
5 Pioneer Road, Faringdon,
Oxfordshire SN7 7BU
[phone]
[email protected].uk
450
Ground
Level
2000 500
Foundation 2 no. pads
300x300x700mm in
C20 concrete
(recommendation only)
100
1900 Ctrs
Surface fix