
Pag 10
DETECTA-6
DETECTA-6
The telepnone/monitor display shows information on the centre status or the function
being carried out (arming, disarming, wrong code ...).
Shown when the wrong code is entered or if an incorrect function is carried out:
If the connection/disconnection is not allowed, the display indicates the reason:
The Service code(*) does not have permission to cut off the alarm.
The centre cannot be connected as it is detecting a priority zone (*).
Cannot connect/disconnect as code is associated with connection/disconnection
with key (*).
Indicates that the centre is blocked because 4 consecutive wrong codes have
been entered.
Shown if when the system is disconnected an alarm has gone off in a zone during the
last connection. The zone LEDs show the zones that have set off the alarm.
Display
On: CENTRE DISCONNECTED
Off: CENTRE CONNECTED
Centre Information in Standby (Disconnected) / Connected
Information when Connecting/ Desconnecting centre
After keying in the connection/disconnection code, the following is shown:
(O: ON) The centre has been connected correctly.
(F: OFF) The centre has been disconnected correctly.
After the ON/OFF indication, the User Nº (*) making the connection/disconnection is displayed:
Centre connected by User 3.
User nº: The Detecta-6 alarm centre has up to 8 user codes, numbered from 1 to 8, that enable connection/
disconnection of the alarms, with certain specific features (see User Codes chapter).
The initial user code is user code nº 1, also known as «Master User Code» which is 1111 by default ( it is advisable
to change the user codes for codes which only the user knows).
Service code: The connection code programmed for user nº 5, which can only be used to connect the centre, never
to disconnect it. It is usually used by service staff (cleaning service, maintenance,..)
Priority zone: These zones (configured by the installer) that do not allow the centre to connect if any of the
detectors are detecting anything at the time.
Connection/Disconnection with key: Depending on the installation, the centre may be configured to connect/
disconnect by means of a key (lock). In this case, the code associated with connection/disconnection by key is the
one corresponding to user 7. Otherwise, the user 7 code connects/disconnects the centre by means of the code it
has been assigned.