Fiamma F45s Series Setup guide

amma.com
F45 • Maintenance and repairs

Copyright ©2014 Fiamma SpA - 2
B
D
A
C
12
3
1
2
2
121
1
2
3
INDEX
F45 • Maintenance and repairs
LEAD BAR INCLINED
p.3
LEAD BAR
DOES NOT CLOSE PROPERLY
p.4
FABRIC REPLACEMENT
p.6
ARMS REPLACEMENT
p.18
INDEX
Necessary tools:
Torque or ratchet wrench 10 and 13 mm
Philips and Flat screwdriver
Meter
5 minutes
1 person
Necessary tools:
10 minutes
1 person
Necessary tools:
20 minutes
2 persons
Necessary tools: +
30 minutes
2 persons
Necessary tools: +

Copyright ©2014 Fiamma SpA - 3
A.1
A.2
INDEX
A • Lead bar inclined
Problem:
A.1 • The lead bar of the awning
is lower on one side (left or right).
Warning: Ensure that shock
absorber bolts are not
blocked in the upper slots.
Solution:
A.2 • Adjust the upper bolt of
the Dual Shock Absorber by
tightening or loosening slightly
on the side where the lead bar
is lower (wrench 10mm).
LEAD BAR INCLINED

Copyright ©2014 Fiamma SpA - 4
B.1
INDEX
B • Lead bar does not close properly
Solution:
B.1 • Open the awning and
locate the end part of the
roller tube (Presto Fix).
LEAD BAR DOESN’T CLOSE PROPERLY
Problem:
B.1 • The lead bar of the awning
doesn’t close properly in the left side.

Copyright ©2014 Fiamma SpA - 5
B.3
INDEX
B.3 • With a flathead screwdriver,
turn the left side of the Presto Fix
clockwise (downwards) of one
or two shots.
B • Lead bar does not close properly

Copyright ©2014 Fiamma SpA - 6
C.1
C.2
C.2
INDEX
C • Fabric replacement
C.1 • Fully open the awning.
FABRIC REPLACEMENT
C.2 • Remove the screws on both of
the end covers as shown in images.

Copyright ©2014 Fiamma SpA - 7
C.3
INDEX
C.3 • Unhook the upper case
cover by lifting it upwards.
For F45 L: slide it by pulling it
from the left side before removing
the end cap (see C.6).
C • Fabric replacement

Copyright ©2014 Fiamma SpA - 8
C.4
C.5
INDEX
C.4 • Remove the two legs
from the lead bar of the
awning (wrench 10 mm).
C • Fabric replacement
C.5 • Remove the screws
that secure the fabric on both
sides of the lead bar.

Copyright ©2014 Fiamma SpA - 9
C.6
C.7
INDEX
C.6 • Remove the second and
third screw from the left end cap.
C.7 • Remove
the left end cap.
C • Fabric replacement

Copyright ©2014 Fiamma SpA - 10
C.9
C.10
C.8
INDEX
C.9 • Remove the roller tube from
the lead bar of the awning.
C.10 • Slide the new fabric in
the lead bar of the awning.
C • Fabric replacement
C.8 • Remove the roller
tube from the right end cap
and roll up the fabric.