First Alert FA560VKP User manual

R
K0022-2UG 8/02
FA560VKP
Voice Keypad
User Guide
This document provides Operating Instructions for your keypad’s voice features. Refer to your
security system User Guide for all other security system functions and operating procedures.
Message Center
The FA560VKP keypad features a voice message
center that lets you record and playback one message.
•The message can be up to 2.5-minutes long
•The message remains in the keypad’s memory until a
new message is recorded.
•The volume control of the message is adjustable.
•Refer to the procedures below when using the
Message Center functions.
A
B
C
D
6
4
7
BYPASS
9
CHIME
#
3
STAY
5
TEST
8
CODE
0
2
AWAY
1
OFF
MAX
READY
INSTANT
*
RECORD
STATUS
ARMED MESSAGEREADY
PLAY
VOLUME
VOICE FUNCTION
FA560VKP-002-V1
FA560
To record a message: Press #
FUNCTION + 0 VOICE + 1 OFF RECORD keys.
The red MESSAGE indicator will light, indicating recording in progress.
Note: A message cannot be recorded during the Exit Delay period.
To end recording: Press 1 OFF
RECORD key.
The red MESSAGE LED will flash indicating a message waiting to be
played. After the message is played once, the MESSAGE LED will go
out.
To play a message: Press #
FUNCTION + 0 VOICE + 3 STAY PLAY keys.
The recorded message plays and the red MESSAGE LED turns off. The
recorded message will remain in memory until a new message is
recorded.
To adjust the volume: Press #
FUNCTION + 0 VOICE + 2 AWAY VOLUME keys,
then press the desired volume control key [3]
9 XS RU >@ ; GRZQ
Note:
•
Adjusting message volume also adjusts status volume. Volume
cannot be adjusted while playing a message.
•
Each time you enter the command to adjust the volume, the word
“CHECK will be heard to verify the current setting.

Chime and Status Features
Voice Chime
You can set the keypad(s) to announce faulted (opened) entry/exit or perimeter zones whenever
the control panel’s Chime mode is on by turning on the Voice Chime mode.
To turn Voice Chime On/Off:Press the #
FUNCTION + 0 VOICE + 2 AWAY VOLUME + 4MAX
keys.
When on, any faulted zone(s) causes a voice status annunciation, chime,
and display. When off, the sounder will still provide chime when the
control’s Chime mode is on.
Voice Status
You can use the STATUS [✱] key to announce system status and display any system and/or zone
faults (if they exist) by first turning on the Voice Chime mode (see above). When Voice Chime
mode is on, pressing the STATUS [✱] key displays and announces current system status and
zone descriptors (programmed by your installer) of faulted zones. If zone descriptors are not
programmed, the respective faulted zone numbers are announced.
To Announce Status: Press the #
FUNCTION + 0 VOICE + ✱READY
STATUS keys once. (Voice Chime mode
must be “on”; see above.)
The respective system status is announced (e.g. “Disarmed Ready to
Arm”or “Disarmed Not Ready to Arm”).
Note: Status cannot be announced during the Exit Delay period.
To Announce Faults: Press the ✱READY
STATUS key a second time within 10 seconds of the first
press.
Up to 3 faulted zones are announced with their zone descriptors, if
programmed. If zone descriptors are not programmed, the respective
zone numbers are announced.
R
149 Eileen Way, Syosset, N.Y. 11791
Copyright 2001 PITTWAY CORPORATION
¬.8* l
K0022-2UG 8/02