Fisher-Price RAINFOREST K4562 User manual

www.fisher-price.com
K4562
L1345
™
K4562
L1345

Mat
Butterfly Arch
Giraffe Tube
Tube
4 Leaves
Assembled Parts
2

Battery Installation
• Slide the soft giraffe up to access the battery
compartment.
• Loosen the screws in the battery compartment
door with a Phillips screwdriver. Remove the
battery compartment door.
• Insert three “C” (LR14) alkaline batteries.
Hint: We recommend using alkaline batteries
for longer battery life.
• Replace the battery compartment door and
tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Slide the soft giraffe back down to cover the
battery compartment.
• If this toy begins to operate erratically, you may
need to reset the electronics. Slide the power/
volume switch off and then back on.
• When sounds or lights become faint or stop,
it’s time for an adult to change the batteries!
• Protect the environment by not disposing
of this product with household waste
(2002/96/EC). Check your local authority
for recycling advice and facilities
(Europe only).
Battery Safety Information
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or ruin
your toy. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the toy. Dispose of batteries safely. Do not
dispose of the product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy
before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
1.5V x 3
“C” (LR14)
3

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. K4562c-0920
© 2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
Please keep this instruction sheet for future reference, as it contains important information.
Adult assembly is required.
Requires three "C" (LR14) alkaline batteries (not included).
Tool required for battery installation:
Phillips screwdriver (not included).
Consumer Information

Assembly
• "Snap" the tube into the giraffe tube, as shown.
• "Snap" the butterfly arch into the bottom of the
hub, as shown.
• "Snap" the four leaves into the hub.
Tube
Giraffe Tube
Butterfly Arch
Button
• Insert the button at the bottom of each tube into
the slot in each corner of the mat.
1
2
3
4
5
Hub
Leaf
Hub

Music, Lights and Nature Sounds!
6
WARNING
To prevent entanglement injury,
never place the gym in a crib or playpen.
Never add strings, ties or other products to the gym.
• Hang the activity toys from loops or links around the gym.
• Slide the power/volume switch on the hub to on with low volume , on with
high volume , or off О.
• Slide the mode select switch on the hub to:
for music, lights and nature sounds.
for nature sounds and lights.
for baby-activated music. Lights and music respond to baby’s movement.

Storage and Care
7
Mat
• Remove the arches and activity toys from the mat.
• Machine wash the mat inside a pillow case in cold
water on the gentle cycle. Do not use bleach. Line
dry the mat.
Arches and Activity Toys
• Wipe with a clean cloth dampened with a mild
soap and water solution. Do not immerse.
• Pull the lower arch from the hub.
• Fold the arches together.
1
2
• To set up again, pull the lower arch from the
hub and unfold the arches.

(United States Only)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
Note: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
FCC Statement
8
This Class B digital apparatus complies with
Canadian ICES-003.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received,
including interference that may cause
undesired operation.
ICES-003
Cet appareil numérique de la classe Best conforme à
la norme NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée seulement
aux conditions suivantes: (1) il ne doit pas produire de
brouillage et (2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique reçu, même
si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
NMB-003