Fisher-Price NONE FOUND P5331 User manual

1www.fisher-price.com
P5331

2
WARNING
To prevent entanglement
injury, never place gym in
a crib or playpen.
Never add strings, ties or
other products to the gym.
Parts
2 Tubes
2 Hanging Toys Inflatable Ball
Quilt
2 Supports
• Please keep this instruction sheet for
future reference, as it contains
important information.
• Adult assembly is required.
• No tools required for assembly.
Consumer
Information

3
Straps
Overhead Gym
1
• Place the quilt, print side up, on a
flat surface.
• Fit the "T" end of each strap on the quilt
through the slots in the supports. Pull up
on the quilt to be sure it is secure.
Straps
Slots Quilt
Supports
2
• Locate both straps on the bottom of one
of the tubes.
• Fit the ends of each strap into the
support post.
• Turn the support over and fasten
the straps.
• Repeat this procedure to attach the
remaining tube ends to the supports.
Tubes
Straps
Support

4
• Remove the toys and inflatable ball from
the straps on the arches.
• Place the toys on the quilt for baby.
3
• Squeeze the stem to inflate the ball.
• Fasten the toys and inflatable ball to the
straps on the arches.
Convert for
Tummy-Time Play
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. P5331pr-0920
©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA

5
1
• Slide each tube through the sleeve in each
side of the quilt.
Crawl-Through Fun
Tube
Sleeve 2
• Position the supports so the slots are
facing inward.
• Locate both straps on the bottom of one
of the tubes.
• Fit the ends of each strap into the
support post.
• Turn the support over and fasten
the straps.
• Repeat this procedure to attach the
remaining tube ends to the supports.
Straps
Support
Post

6
Care
3
• Fit the plastic tabs on each end of the
quilt into the slots in the supports.
4
• Attach the toys and the ball to the fasteners
on the sleeves.
• Machine wash the play quilt in cold water
on the gentle cycle. Do not use bleach.
Tumble dry on low heat.
• Surface wash the tubes, toys, ball and
supports with a mild cleaning solution
and damp cloth. Do not use bleach.
Rinse clean to remove residue.