Fisher-Price GEOTRAX L5893 User manual

www.fisher-price.com
L5893

A. 3 End Rails
B. Small Tower with
Toll Booth
C. 3 Small Towers
D. Main Tower
E. 4 Side Rails
F. 4 Supports
G. Span
H. 2 Span Ends
Part not shown: 1 Figure
Parts
A
C
H
F
x3
B
x4
x2
x3
x4
D
E
G

• Locate the square mark on both the
side of a support and on the span
assembly. Match the squares and
“snap” the support into the underside
of the span assembly, as shown.
• “Snap” the remaining supports into
the span matching the square marks
on each.
•“Snap” the span ends onto
the span.
Assembly
• “Snap” the four side rails into
the main tower, as shown.
SPAN ENDS
SPAN
1
2
SUPPORTS
SQUARES
3
MAIN TOWER
SIDE RAILS

• Locate the square mark near the
bottom of each small tower.
• With the square marks facing
out, “snap” the small towers and
tower with toll booth to the side
rails, as shown.
Assembly
• “Snap” the end rails to the small
towers, as shown.
4
END RAILS
SMALL TOWER
WITH TOLL BOOTH
5
• “Snap” each of the towers onto the
span assembly.
Assembly is now complete.
6
SMALL
TOWERS
SQUARE

So Many Ways to Play!
• Remove the supports for a ground-
level bridge.
• The toll gate lifts and lowers.
Multiple Levels
of Track Layouts!
1
• To build a ground-level layout, separate the span
assembly from the supports and place the span
assembly on the floor.
• Attach straight tracks (sold separately) to either
end of the span assembly.
Track not included.
2
• Use supports and straight tracks (sold
separately) to build an elevated assembly.
3
• Use an Elevation Track Pack™(sold separately)
to access the suspension bridge.
• Attach ramp assemblies (sold separately) to
the ends of the span.

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. PRINTED IN CHINA
©2007 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. L5893pr-0920
Visit www.fisher-price.com to see
the entire world of GeoTrax®accessories!
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
No tools needed for assembly.
Wipe the toy with a clean, damp cloth. Do not immerse.