Fluke 718 Series Owner's manual

Supplement
© 2007-2014 Fluke Corporation. 
All rights reserved.
Title: 715 Inst.Sht. Supplement Issue: 6
Part Number: 650314 Issue Date: 1/14
Print Date: July 1997 Page Count: 2
Revision/Date: 3, 8/05
This supplement contains information necessary to
ensure the accuracy of the document described
above.

715 Instruction Sheet Supplement
4/09 1
Change #1
Under General Specifications, add the following:
Protection Class: Pollution Degree II
Change #2
Under Specifications,table DC V Input and Output
change the following:
From: Voltage drive capability: 1 mA
To: Voltage drive capability:
SN < 9494143 = 1 mA
SN > 9494143 = 10 mA 10 V, 3 mA > 10 V
Change #3
On the second panel, under International Symbols,
add the following:
Conforms to Australian C-Tick
directives
Change #4, 47219
Under Specifications, DC mA Output, Source
mode, Compliance, add the following:
750 at 20 mA with HARTresistor on and
battery voltage 6.8 V
Change #5
Under Span Check Feature, replace steps 3 and 5
with the following:
3. Press the scroll keys simultaneously to store
the 0% value.
5. Again, press the scroll keys simultaneously
to store the 100% value.

Supplement 714 Instruction Sheet
2 1/14
Change #6, 67381
On the second panel, under International Symbols,
add:
Conforms to relevant South Korean
EMC Standards.
Under General Specifications, add:
Electromagnetic Compatibility......Applies to use in
Korea only. Class A
Equipment (Industrial
Broadcasting &
Communication
Equipment) [1]
[1] This product meets requirements for industrial
(Class A) electromagnetic wave equipment and
the seller or user should take notice of it. This
equipment is intended for use in business
environments and is not to be used in homes.