Forest garden UPK02FP User manual

TAPE MEASURE
POZI DRIVE
SCREWDRIVER DRILL
HAMMER
Forest Garden Ltd, Unit 288 Hartlebury Trading Estate, Hartlebury, Worcestershire, DY10 4JB
Important : Assembly of this
product requires a minimum
of two adults
MUST PRE DRILL
Issue 0214
UPK02FP
FIXING PACK
Pergola 10’x 10’
Thank you for choosing this Pergola manufactured by the UK's largest manufacturer of timber garden products. In order
to gain the most benefit from it, please note the following:
- Exercise particular care and follow instructions.
- This Pergola is pressure treated to ensure the longevity of all timber components and protect against rot. This may leave
a colour difference on some parts that will even out as the moisture content stabilises.
- In line with your statutory rights, please check all parts prior to assembly, as assembly of damaged parts may be
deemed to be acceptance and this may affect the remedies you are entitled to. If the product is not constructed in
accordance with the instructions, or is altered in anyway (e.g. painted), the manufacturer cannot be held liable for any
resulting damage.
- This product will shrink and swell as a result of varying moisture content.
- Please keep all plastic bags and small parts away from children in order to reduce the risk of suffocation.
- Important Note : Do not lean or stand on rafters during assembly they are not load bearing.
- If there are any technical queries with the product, please contact our customer help line on 0333 7777 089 between the
hours of 8.30 am and 5.00 pm Monday to Friday.
RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.
4
25mm screw qty 56
60mm screw qty 24
USU94BI Qty 4
‘POST’
U’bracket qty 14
Loose Components
URCB12BI Qty 9
‘RAFTER’
UCBCBI Qty 8
‘BRACE’
2860mm
2860mm

Pre - drill all holes before fixing for each step.
We recommend the use of post supports or placing the posts in to the ground
Place two of the posts on the floor
2860mm apart.
Slot one of the rafters into the posts
with equal overhang on both sides.
Fix using 2x 60mm screws for
each post as shown.
Place the braces so they are tight
and flush with the posts and the
rafters.
Fix each using 2x 60mm screws
(Repeat for remaining posts)
Place a U’bracket so it is central on
the top of the post and rafter as
shown.
Position the remaining 5 brackets
along the rafter 445mm apart.
Fix each bracket using 2x25mm
screws.
Position the two frames you have
previously assembled 2860mm
apart.
Connect the two assemblies placing
a rafter at each end. Slot these into
the bracket, making sure the
overhang is the same.
Fix using 2x25mm screws and
the bracket for each end,
Repeat for each rafter
Step 2
Step 1
Step 3
Step 4
Fix the remaining braces the same
as in step 1.