Fri-Jado Multi Deck 25 Hot User manual

WWW.FRIJADO.COM Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
MODELS
Multi Deck 25 Hot
Multi Deck 40 Hot
Classic Deck Hot
Classic Deck Cold
INSTALLATION
MANUAL
MULTI DECK
CLASSIC DECK
- NOTICE -
This manual is prepared for the use of trained Service Technicians and
should not be used by those not properly qualified. If you have attended
a trianing for this product, you may be qualified to perform all the proce-
dures in this manual.
This manual is not intended to be all encompassing. If you have not
attended a training for this product, you should read, in its entirety, the
repair procedure you wish to performto determine if you have the neces-
sary tools, instruments and skills required to perform the procedure.
Procedures for which you do not have the necessary tools, instruments
and skills should be performed by a trained technician.
Reproduction or other use of this Manual, without the express written
consent of Fri-Jado, is prohibited.
Model Classic Deck Hot Model Multi Deck 40 Hot

TABLE OF CONTENTS
Page 2 Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
EMPTY PAGE

Page 3
Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
INDEX
Index ............................................................................................................................... 3
General technical data .................................................................................................... 4
Technical Data U.S. Standard Models .................................................................................................4
Technical Data U.S. Special Models ....................................................................................................4
Installation instructions .................................................................................................... 5
Unpacking and removing the unit from the pallet ...............................................................................5
Location/Airgrid ...............................................................................................................................8
Electrical supply ................................................................................................................................9
Casters ............................................................................................................................................9
Test run ............................................................................................................................................9
Instructions for operators ...................................................................................................................9
Installation drawings ..................................................................................................... 10
Multi Deck 25 hot ...........................................................................................................................10
Multi Deck 40 hot ...........................................................................................................................11
cLASSIC dECK hot ..........................................................................................................................12

Page 4 Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
GENERAL TECHNICAL DATA
This manual covers the Multi Deck 25 and 40 Hot and the Classic Deck Hot and Cold series merchan-
diser cabinets. The cabinets come in two sizes, 25 and 40 inches.
• Multi Deck 25 Hot - Merchandiser 25 Inches wide.
• Multi Deck 40 Hot - Merchandiser 40 Inches wide.
• Classic Deck Hot – Merchandiser 25 Inches wide.
• Classic Deck Cold – Merchandiser 25 Inches wide.
All of the information, illustrations and specifications contained in this manual are based on the
latest product information available at the time of printing.
Type MD 25 Hot MD 40 Hot Classic Deck Hot Classic Deck Cold
Power (W) 3200 3700 3200 1380
Fuses needed with power connection 208V,
1N~60Hz (1 phase with zero)
1x 20 A 1x 20 A 1x 20 A -
Fuses needed with power connection 115V,
1N~60Hz (1 phase with zero)
- - - 1x 20 A
Standard plug from factory NEMA 6-20P NEMA 6-30P NEMA 6-20P NEMA 5-20P
Net weight 551 lbs 683 lbs 551 lbs 408 lbs
Gross weight 716 lbs 858 lbs 716 lbs 574 lbs
Height (mm) 75 5/16” 75 5/16” 75 5/16” 75 5/16”
Width (mm) 24 3/8” 39 3/8” 24 3/8” 24 7/8”
Depth (mm) 37 5/16” 37 5/16” 40 ¾” 37 5/16”
Tools
• Standard set of tools.
• Metric wrenches, sockets and hex socket key wrenches.
• VOM with AC current tester (any VOM with a sensitivity of at least 20,000 ohms per volt can be
used).
• Temperature tester.
TECHNICAL DATA U.S. STANDARD MODELS
GGG
W
G

Page 5
Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
UNPACKING AND REMOVING THE UNIT FROM THE PALLET
NOTE: Perform this action safely with two
people
Remove the crate from the unit by taking of the
following parts:
1: top
2+3: front and back
4: sides
Follow the instructions as given in the next pages.
After the unit is unpacked, you can apply the
bottom plinth as shown in the pictures on the
separate instruction sheet.
Read the instructions before proceeding.
Immediately after unpacking the merchandiser, check for possible shipping damage. If the merchan-
diser is found to be damaged, save the packaging material and contact the carrier within 15 days of
delivery.
INSTALLATION INSTRUCTIONS

Page 6 Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
Unit after removal of the crate
Remove the screws from the board on the front
side of the pallet as shown above
A
1. Carefully tilt the unit slightly
2. Remove the board-and-beam assembly
3. Carefully lower the unit until it rests on the
floor
B
1. Remove the screws from the connecting
beam
2. Remove the disconnected beam
C

Page 7
Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
Carefully let the unit slide onto its wheels
D
WARNING! Prevent the unit from rol-
ling away on the casters.
E
Remove top transport safety beam
F
1. Carefully tilt the shelf slightly
2. Remove the transport beam
3. Repeat for bottom shelf
G

Page 8 Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
LOCATION/AIRGRID
The merchandiser must be installed on a level surface. The installation location must allow adequate
clearances for servicing and proper operation.
Take care that a free airflow around the top is
secured. This is to prevent the electronic ballast
for overheating.
The minimum temperature of the environment should be 68°F for the Multi Deck 25/40 hot and Clas-
sic Deck hot. The maximum temperature of the environment should be 72°F and the relative humidity
should be maximum 65%.
Note: Strong air-currents due to draughty doors, air-conditioninig outlets etc. will be detrimental to the
proper operation.
Note: The maximum load per shelf is 45 lbs. The load must be equally distributed over the shelf.
Remove transport safety shelfs (3x)
H
1
2
3

Page 9
Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
Prior to installation, test the electrical service to assure that it agrees with the specifications on the
machine data plate located on the right side panel near the controls.
The connecting cable for the unit must be equipped with an approved plug connection. If use is to be
made of a permanent connection, the connecting cable must be connected to a manual on/off switch
that is installed near the unit in a clear visible manner.
ELECTRICAL SUPPLY
For a 1-phase 208V or 115V ~ circuit with
neutral, the unit must be connected according to
the figure below.
For a 3-phase 208 V ~ circuit without neutral,
the unit must be connected according to the
figure below.
208V, 3~60Hz 208V or 115V, 1N~60Hz
1 2 3 4 5 6
N
L1
1 2 3 4 5 6
L2
L1 L3
Each merchandiser is furnished on 4 casters of 3 1/8”. The Multi Deck 25 hot and Classic Deck hot &
cold have 2 rigid casters on the back side and 2 locking swivel casters on the customer side. The Multi
Deck 40 hot is furnished with 2 swivel casters on the back side and 2 locking swivel casters on the cus-
tomer side.
CASTERS
Operate the Multi Deck 25/40 hot and Classic Deck hot at maximum temperature setting to insure the
proper working of the unit. Operate the Classic Deck cold merchandiser at minimum temperature set-
ting to insure the proper working of the unit.
TEST RUN
INSTRUCTIONS FOR OPERATORS
After installation of the Multi Deck, the operator of the unit has to be instructed.
The instruction has to cover the following subjects:
• How to switch the unit on.
• Working of the unit.
• Run through the user manual.
• How to react for information or service calls.

Page 10 Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
INSTALLATION DRAWINGS
MULTI DECK 25 HOT
Description belonging to the lables on the drawings
Label Description
1 Power cable, length 80” *
*) length is measured from the point where the cables coms out of the unit

Page 11
Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
MULTI DECK 40 HOT

Page 12 Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
CLASSIC DECK HOT

Page 13
Installation Manual Multi Deck 25/40 hot / Classic Deck 25 hot/cold form 9123655 rev. 03/2006
Fri-Jado Inc. • 180 Kehoe Blvd. • Carol Stream, Ill. 60188 • USA • tel. [phone] • fax [phone] • toll free 877-FRI-JADO • [email protected] • www.frijado.com