FRO­NIUS TransSteel 2200c User manual

/ Perfect Welding / Solar Energy / Perfect Charging
42,0426,0263,EN 002-04042018
1
Set the synergic welding process
When setting a welding power parameter, the
remaining parameters are set automatically
MMA welding
TIG welding
The welding power parameters can be adju-
sted individually
2
Set the filler metal and shielding gas
2.1. 3.
3
Set the operating mode
2-step mode: short weld seams, tacking work
4-step mode: longer weld seams, high level of
comfort
Special 4-step mode: additional settings for star-
ting and nal current
Spot welding: for overlapping sheets / stitch
welding: light-gauge sheet welding and air-gap
bridging
4
Set the welding power
Sheet thickness
Welding current
Wire speed
select desired parameter
set desired parameter
5
Adjust the parameters for correction
Arc length correction
Welding voltage
Arc-force dynamic
select desired parameter
set desired parameter
6
Optimise welding results
1. Measure the welding circuit resistance r
2. Set the mains fuse so that the device switches o
before the mains fuse trips.
The description of the aforementioned measures can be
found in the Operating Instructions of the power source
TransSteel 2200c
Quick Guide to synergic welding
SAFETY
Before working with the device, ensure that you have read and understood all the documents provided in hard copy and online.
This document does not describe all the functions of the device. For a complete description of the device, refer to the Operating Instructions.
Operating Instructions:

Display service parameters
EasyJobs
Retrieve:
1x
Save:
Delete:
Activating/deactivating the key lock
Exiting the Setup menu
Available parameters: Example of display:
Firmware version
Welding program conguration
Current welding program
Arc time in hours
Motor current for wire drive in ampere
2nd menu level (Service)
MIG/MAG Synergic Setup menu
1. 2. 2.
Parameters:
Gas pre-ow time
Gas post-ow time
Slope (2-step, special 4-step)
Starting current (2-step, special 4-step)
Final current (2-step, special 4-step)
Starting current duration (2-step)
Final current duration (2-step)
Feeder inching speed
Burn-back eect
Length of wire that is fed before the safety cut-out
trips
Spot welding time / interval welding time
Interval pause time
Operating mode for stitch welding
Restore factory setup
Level 2 Setup menu
Country-specic setting
Welding circuit resistance
Welding circuit inductivity
Real Energy Input
Mains fuse protection
Arc length correction display
MIG/MAG Manual Setup menu
2.
1. 2.
Parameters:
Gas pre-ow time
Gas post-ow time
Feeder inching speed
Burn-back eect
Ignition current
Length of wire that is fed before the safety
cut-out trips
Spot welding time / interval welding time
Interval pause time
Operating mode for stitch welding
Restore factory setup
Level 2 Setup menu
Country-specic setting
Welding circuit resistance
Welding circuit inductivity
Real Energy Input
Mains fuse protection
MMA Setup menu
1. 2. 2.
Parameters:
HotStart current
HotStart time
Anti-stick
Restore factory setup
TIG Setup menu
2.2.1.
Parameters:
Pulse frequency
UpSlope
DownSlope
Starting current
Reduced current
Final current
Gas post-ow time
Tacking
Restore factory setup
Level 2 Setup menu
Country-specic setting
Mains fuse protection
Level 2 Setup menu
Country-specic setting
Welding circuit resistance
Welding circuit inductivity
Mains fuse protection