FURNITUREBOX MILAN User manual

MILAN
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/milan-barstool
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
PLEASE BE AWARE THAT QUANTITIES ARE PER CHAIR
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
30 MINUTE
BUILD
MAXIMUM
CAPACITY 150Kg

Follow us on Instagram
@furniturebox_uk
STEP 1
Attach the top cross-bar piece between the 2 separate leg frame
pieces using 1 x curved washer [E] followed by 1x spring washer [F]
and then 1 x screw [B] on each side. Finger tighten screws until all
pieces are in the correct place.
Then attach the foot bar
rest at the bottom front
of the leg frame - use 1 x
screw [C] on each side.
Next, slot the seat back
into the holes of the leg
frame. Secure each side
with 1x curved washer
[E] followed by 1 x spring
washer [F] and then 1 x
screw [A].
Once all components
are in place, tighten
screws with Allen keys
[G and H]

www.furniturebox.co.uk
STEP 2
Attach the seat pad.
Carefully align with
holes in the underside
of the seat pad with the
holes in the seat frame
and connect using 1 x
washer [D] followed by 1
x spring washer [F] then
1 x screw [A] for each of
the 4 holes.
Once all screws are in
place and nger tight,
you can fully tighten
them with Allen key [G].
FULL ASSEMBLY INSTRUCTIONS
STEP 3
Check stability. Your
stool is now ready to
use!

www.furniturebox.co.uk
www.furniturebox.co.uk