FURNITUREBOX ATHENS User manual

ATHENS
COFFEE TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/athens-coffee
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
30 MINUTE
BUILD

Follow us on Instagram
@furniturebox_uk
STEP 2
Next, connect the central leg
[4] to the base plate [3] using 2x
washer [B] followed by screw [A].
Tighten with Allen key [C] then
cover holes with 2x pads [E].
STEP 1
Use a clear, at, soft surface to
avoid bumps or scratches.
First, take base plate [3] and
add 6x wooden dowels [D].
STEP 3
Connect both the outer
legs [5] to the base
plate. Use 2x washer [B]
followed by screw [A].
Tighten with Allen key
[C] then cover holes with
2x pads [E].

www.furniturebox.co.uk
STEP 4
Attach connecting plate [2] to
the tops of the table legs. Use
2 x washers [B] followed by
screws [A] per leg - 6 washers
and screws total. Tighten with
Allen key [C].
FULL ASSEMBLY INSTRUCTIONS
STEP 5
Carefully place table top
[1] at on oor, upside
down. Place connecting
plate [2] upside down
on top of it. Line up the
holes and secure the
connecting plate to
the table top using 4 x
washer [B] then screw
[A] - 2 sets on each side.
Tighten with Allen key
[C] and cover holes with
4 x pads [E].
STEP 6
ATTENTION: Carefully turn your
coffee table onto its feet so its
right way up. Check stability.
Your table is now ready to use.

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.