MAINTENANCE TIPS
The Seeker050 series requires no routine maintenance other than periodic cleaning. To
clean the instrument, use a soft dry cloth. Never use a wet cloth, solvents or water.
Although the probe and camera head are water, dust and oil proof to P67 standards,
refrain from immersing them in liquids or allowing them to come into contact with
corrosive chemicals. Remember that the grip is not waterproof.
Never forcibly insert or bend the probe. Nor should you bend it in more than a 2 inch
radius, or use it like a stick to clear pathways or debris.
Remember to replace the camera head’s protective rubber cap after each use of the
Seeker050. f your videos have spots, gently clean the camera head with a clean,
dry cloth.
WARRANTY INFORMATION
The Seeker050 series USB Video nspection Systems from General Tools & nstruments
(General®) is warranted to the original purchaser to be free from defects in material and
workmanship for a period of 3 years. Subject to certain restrictions, General will repair
or replace this instrument, if after examination, it is determined by General to be
defective in material or workmanship.
This warranty does not apply to damages that General determines to be from an
attempted repair by non-authorized personnel or misuse, alterations, normal wear and
tear or accidental damage. The defective unit must be returned to General Tools &
nstruments or a General authorized service center, freight prepaid and insured.
Acceptance of the exclusive repair and replacement remedies described herein is a
condition of the contract for purchase of this product. n no event shall General be liable
for any incidental, special, consequential or punitive damages, or any cost, attorneys
fees, expenses, losses alleged to be
as a consequence of any damage due to failure of, or defect in any product including,
but not limited to, any claims for loss of profits.
RETURN FOR REPAIR POLICY
Every effort has been made to provide you with a reliable, product of superior quality.
However, in the event your instrument requires repair, please contact our Customer
Service to obtain a RGA# (Return Goods Authorization) before forwarding the unit via
prepaid freight to the attention of our Service Center at this address:
General Tools & nstruments
80 White Street
New York, NY 10013
212-431-6100
Remember to include a copy of your proof of purchase, your return address, and your
phone number and/or e-mail address.
6
