Goldmedal 8150 User manual

Part No.88359
Front Load Steamers
Instruction Manual
Model No. 8150, 8151
Cincinnati, OH 45241-4807 SA

Front Load Steamers Model No 8150, 8151
http://www.gmpop orn. om Page 2
SAFETY PRECA TIONS
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
008_051514
DANGER
Improper installation, adjustment, alteration, service, or maintenance can
cause property damage, injury, or death. Any alterations to this equipment will
void the warranty and may cause a dangerous condition. NEVER make
alterations to this equipment. Read the Installation, Operating, and
Maintenance Instructions thoroughly before installing, servicing, or operating
this equipment.
014_051514
WARNING
To avoid burns, DO NOT touch heated surfaces.
DO NOT place or leave objects in contact with heated surfaces.
009_092414
WARNING
ALWAYS wear safety glasses when servicing this equipment.
010_010914
WARNING
No user serviceable parts inside. Refer servicing to qualified service
personnel.
011_051514
WARNING
Read and understand operator’s manual and all other safety instructions
before using this equipment. To order copies of the operator’s manual go to
gmpopcorn.com or write to Gold Medal Products Co., 10700 Medallion Drive,
Cincinnati, OH 45241 USA 1-(800)-543-0862
022_010914

Front Load Steamers Model No 8150, 8151
http://www.gmpop orn. om Page 3
SAFETY PRECA TIONS (continued)
WARNING
DO NOT allow direct contact of this equipment by the public when used in
food service locations. Only personnel trained and experienced in the
equipment operation may operate this equipment.
Carefully read all instructions before operation.
012_010914
WARNING
This machine is NOT to be operated by minors.
007_010914
Note: Improvements are always being made to Gold Medal’s equipment. This information
may not be the latest available for your purposes. It is critical that you call Gold Medal’s
Technical Service Department at 1-800-543-0862 for any questions about your machine
operations, replacement parts, or any service questions. (Gold Medal Products Co. does
not assume any liability for injury due to careless handling and/or reckless operation of
this equipment.)

Front Load Steamers Model No 8150, 8151
http://www.gmpop orn. om Page 4
INSTALLATION INSTR CTIONS
Inspection of Shipment
After unpacking, check thoroughly for any damage which may have occurred in transit. Claims should be
filed immediately with the transportation company. The warranty does not cover damage that occurs in
transit, or damage caused by abuse, or consequential damage due to the operation of this machine, since
it is beyond our control (reference warranty in back of manual).
Manual
Read and understand the operator’s manual and all other safety instructions before using this equipment.
To order copies of the operator’s manual go to gmpopcorn.com or write to Gold Medal Products Co.,
10700 Medallion Drive, Cincinnati, OH 45241 SA 1-(800)-543-0862.
Setup
This unit has been tested at the factory.
1. Remove all packaging and tape prior to operation.
2. Place unit on a sturdy, level base.
3. Prior to plugging in the machine, the Tong Holder may be mounted on either side of unit; on
the preferred side (side away from the wall), locate the mounting hole provided in the
cabinet.
4. One screw is fully inserted into the Tong Holder to act as a stop and hold the Tongs.
5. se the second screw, to attach the Tong Holder to the cabinet.
6. Insert a hole plug in the unused mounting hole (located on cabinet side opposite of Tong
Holder).
7. After setup, the unit should be cleaned prior to use (see Care and Cleaning section of this
manual).

Front Load Steamers Model No 8150, 8151
http://www.gmpop orn. om Page 5
ELECTRICAL REQ IREMENTS
REQ IREMENTS
8150: 120 V~, 700 W, 60 Hz
8151: 120 V~, 785 W, 60 Hz
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
008_051514
Your electrician must furnish sufficient power for proper machine operation. We recommend this
equipment be on a dedicated and protected circuit. Failure to wire properly will void the warranty and
may result in damage to the machine. It is Gold Medal Products Co.’s recommendation that this machine
be plugged directly into a wall outlet. The use of extension cords is not recommended due to safety
concerns, and may cause sacrificed and/or reduced performance. Make sure cord is located to prevent a
trip hazard or unit upset.
Before You Plug In Machine
1. Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
2. Make sure the wall outlet can accept the grounded plugs (where applicable) on the
power supply cord.
3. The wall outlet must have the proper polarity. If in doubt, have a competent
electrician inspect the outlet and correct if necessary.
4. DO NOT use a grounded to un-grounded receptacle adapter (where applicable).
5. Install the unit in a level position.

Front Load Steamers Model No 8150, 8151
http://www.gmpop orn. om Page 6
OPERATING INSTR CTIONS
HEAT CONTROL
This Infinite heat control with on/off positions controls the amount of heat going to the water pan to
generate steam.
PILOT LIGHT
This light gives you a positive indication that the heat element is on. Since these machines use an infinite
heat control (As mentioned above), the element may not be on all the time; the pilot light tells you when
the element is operating.
OPERATION
1. Prepare the Front Load Steamer for operation.
2. Fill the water pan with warm water. NOTE: 4 quarts for the 8150 and 6 quarts for the 8151.
3. Place the hood on top of the water pan.
4. Insert the hot dog bun trays and divider.
5. Turn heat control to the “HIGH” position
6. Place up to 30 hot dogs (8150) or 45 hotdogs (8151) in the hot dog side of the hood and cook for 45
minutes. Be sure to arrange the hotdogs loosely to allow the steam to circulate evenly.
7. After 45 minutes, place 20 more dogs (8150) or 30 more dogs (8151) in the hot dog side and cook
for 30 more minutes.
8. Place several buns in the bun side of the cabinet (Place buns as needed).
NOTE: Leaving buns in too long may result in soggy buns.

Front Load Steamers Model No 8150, 8151
http://www.gmpop orn. om Page 7
CLEANING INSTR CTIONS
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
DO NOT immerse in water.
Always unplug the equipment before cleaning or servicing.
025_020314
WARNING
To avoid burns, DO NOT touch heated surfaces.
DO NOT place or leave objects in contact with heated surfaces.
009_092414
Good sanitation practice demands that all food preparation equipment be cleaned regularly (only use
non-toxic, food grade cleaners). A clean looking, well-kept machine is one of the best ways of advertising
your product.
Follow the directions below to clean and sanitize the unit each day after use.
1. With the machine OFF, unplug the unit and allow it to cool before attempting to clean.
2. Take the hood off of steamer.
3. Empty the water pan.
4. Remove all interior components (bun trays, hot dog tray, divider) and wash with soap and
water, then dry.
5. Wipe surfaces with a soft cloth, dampened with soap and hot water, then dry.
6. Clean the outside of the unit with a soft cloth, dampened with soap and hot water, then dry.
7. Wipe the stainless steel parts with a clean cloth and cleaner designed for stainless steel, such
as Gold Medal Watchdog Stainless Cleaner (Item No. 2088).
DO NOT use oven cleaners or abrasive materials as they will damage parts of the machine.
8. Clean the glass panels with glass cleaner. Gold Medal Watchdog Glass Cleaner (Item No. 2588)
is recommended.
Ammonia cleaners will damage plastic panels. se only non-ammonia cleaners, such as Gold
Medal Watchdog Glass Cleaner (Item No. 2588).

Front Load Steamers Model No 8150, 8151
http://www.gmpop orn. om Page 8
MAINTENANCE INSTR CTIONS
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
008_051514
DANGER
Improper installation, adjustment, alteration, service, or maintenance can
cause property damage, injury, or death. Any alterations to this equipment will
void the warranty and may cause a dangerous condition. NEVER make
alterations to this equipment. Read the Installation, Operating, and
Maintenance Instructions thoroughly before installing, servicing, or operating
this equipment.
014_051514
WARNING
No user serviceable parts inside. Refer servicing to qualified service
personnel.
011_051514
CAUTION
THE FOLLOWING SECTIONS OF THIS MANUAL ARE INTENDED ONLY
FOR QUALIFIED SERVICE PERSONNEL WHO ARE FAMILIAR WITH
ELECTRICAL EQUIPMENT. THESE ARE NOT INTENDED FOR THE
OPERATOR.
027_010914

Front Load Steamers Model No 8150, 8151
http://www.gmpop orn. om Page 9
ORDERING SPARE PARTS
1. Identify the needed part by checking it against the photos, illustrations, and/or
parts list.
2. se only approved replacement parts when servicing this unit.
3. When ordering, please include part number, part name, and quantity needed.
4. Please include your model number, serial number, and date of manufacture (located on the
machine nameplate/data plate) with your order.
5. Address all parts orders to:
Parts Department
Gold Medal Products Co.
10700 Medallion Drive
Cincinnati, Ohio 45241-4807
Or, place orders by phone or online:
Phone: [phone]
[phone]
Fax: [phone]
[phone]
E-mail: inf[email protected]
Web Page: gmpopcorn.com

Front Load Steamers Model No 8150, 8151
http://www.gmpop orn. om Page 10
PARTS BREAKDOWN
*NOTE: The bun tray is lo ated under the short
platform (Pi tured with holes) on both models.
The Bun Tray will not have the holes pi tured.
Item
Model Part Description
1 88269 (8150)
Hood Weldment
88325 (8151) Hood Weldment
2
101032
(8150)
Door Assembly (includes
handle, hinge, glass, and decal)
69685 (8151)
Door Assembly (includes
handle, hinge, glass, and decal)
3 88299 (ALL) Hinge Knob
4 41033 (ALL) Pilot Light
5 38389 (ALL) Knob Control
6 88342 (8150)
Control Box Weldment
88354 (8151) Control Box Weldment
7 88267 (8150)
Body Weldment
88324 (8151) Body Weldment
8 88298 (8150)
Hinge Pin
88331 (8151) Hinge Pin
9 69568 (ALL) Guard for Control Knob
10 12389 (ALL) 8-32 Screw (fastens Guard)
11 69572 (ALL) Divider
12 88260 (8150)
Hot Dog Tray
88319 (8151) Hot Dog Tray
13 88261 (8150)
Bun Tray*
88320 (8151) Bun Tray*
14 47155 (ALL) Rubber Feet
15 88343 (8150)
Control Label
88356 (8151) Control Label
16 87297 (ALL) Heat Control
17 88322 (8151)
Short Platform*
88263 (8150) Short Platform*
Guard and Scre fasteners
for control knob (not sho n).
9, 10
3
4
5
6
7
8
11
13, 17
12
16
15
14
1 2