Goldmedal P-60 User manual

Part No.49064
P-60 / 60 Special
Instruction Manual
Model No.1866, 1866XJ, 2085, 2086, 2656, 2656KC
1866, 1866XJ, 2086 2085, 2656 2656KC
Cincinnati, OH 45241-4807 SA

P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
ttp://www.gmpopcorn.com Page 2
SAFETY PRECA TIONS

P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
ttp://www.gmpopcorn.com Page 3
GENERAL INSTR CTIONS
INSPECTION OF SHIPMENT
npack all cartons and check thoroughly for any damage that may have occurred during transit. Damage
claims should be filed immediately with the transportation company.
SET P
Your new Popper was assembled and tested at the factory. Remove all packing material and tape before
starting operation.
ELECTRICAL REQ IREMENTS
Models 1866, 2086, 2085: 120V, 60Hz, 1220W
Models 2656, 2656KC: 120V, 60Hz, 1300W
Model 1866XJ: 100V, 50/60Hz, 1220W
Your electrician must furnish sufficient power for proper machine operation. We recommend this popper
be on a dedicated and protected circuit. Failure to wire properly will void the warranty and may result in
damage to the machine.
It is Gold Medal® Products Company’s recommendation that this machine be plugged directly into a wall
outlet. The use of extension cords is not recommended. This may cause sacrificed and/or reduced
performance and can become a safety hazard.
BEFORE YO PL G IN THE MACHINE
1. Make sure the wall outlet can accept the grounded plugs (where applicable) on the power supply
cord.
2. The wall outlet must have the proper polarity. If in doubt, have a competent electrician inspect
the outlet and correct if necessary.
3. DO NOT use a grounded to un-grounded receptacle adapter.

P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
ttp://www.gmpopcorn.com Page 4
OPERATING INSTR CTIONS
CONTROLS AND THEIR F NCTIONS
LIGHT AND WARMER SWITCH: Turns on the heat to the bottom corn pan and heat light.
KETTLE MOTOR SWITCH: Turns on the motor which drives the kettle agitator.
KETTLE HEAT SWITCH: Supplies power to the thermostat controlled kettle
A TO SH T OFF
The 1866 and 2656 Models are equipped with an auto shut-off mechanism. If the kettle heat is on with no
product popping for fifteen minutes, the auto shut-off will turn off the kettle heat element and the kettle
heat switch will flash. To pop a new batch of corn, cycle the kettle heat switch off and then back on.
AMO NT OF POPCORN AND OIL
Your new Popper is equipped with a 6 oz corn measuring cup (Part No. 49049).
Corn charge – 6 oz.
Oil charge – 1.6 to 2.0 oz.
Flavacol – 1 teaspoon
POPPING INSTR CTIONS
1. Turn Kettle Heat and Kettle Motor switch on.
2. Make a test pop by putting 3 kernels of corn and 1 oz. (30 ml) of oil into the kettle.
3. When the 3 kernels have popped, load the kettle with corn and oil charge.
4. When corn has popped, dump the kettle.
5. Repeat cycle starting with step number 3 above; always pop 3-5 batches for best popcorn.
Kettle Heat Switch
Part No. 42798 (1)
Kettle Motor Switch
Part No. 42532 (2)
Light And Warmer Switch
Part No. 42532 (2)
Switch Box Label
Part No. 48502 (1)

P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
ttp://www.gmpopcorn.com Page 5
CARE AND CLEANING
KETTLE
1. Each time you finish a series of popping, allow the kettle to cool down and wipe the outside of the
kettle with a soft cloth to remove any oil drippings left behind.
2. After you finish popping for the day, allow the kettle to cool until it is not too hot to handle, but
still warm.
3. nplug the kettle and remove it from the machine.
4. With a cloth, wipe out the inside of the kettle, kettle lid, crossbar, outside and underneath of the
kettle.
NOTE: DO NOT place the kettle in water. This will cause damage to the electrical components and will
void your warranty.
CABINET
Cleaning the cabinet of your machine is easy. Take a clean cloth and wipe excess grease from the glass.
Wipe the outside of the machine also.
NOTE: Never use a glass or plastic cleaner that contains ammonia. It will crack the plastic on the machine.

P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
ttp://www.gmpopcorn.com Page 6
MAINTENANCE INSTR CTIONS

P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
ttp://www.gmpopcorn.com Page 7
ORDERING SPARE PARTS
1. Identify the worn or broken part by checking it with the illustrations and parts list.
2. When ordering parts, include part number, part name, and quantity required.
3. Include your model name and machine serial number (found on nameplate) with your order.
4. Address orders to:
Parts Department
Gold Medal® Products Co.
10700 Medallion Drive
Cincinnati, Ohio 45241-4807
Or place orders at:
[phone]
[phone]
Fax: [phone]
E-mail : [e-mail]
www.gmpopcorn.com

P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
ttp://www.gmpopcorn.com Page 8
Number Part No Description Quantity
147060 Spur Gear 1
243434 Agitator Bearing Hub 1
347106 Needle Bearing 1
441742 Set Screw 3
569710 Agitator S aft 1
649017 Front Lid Wit Formed Lifter 1
749016 Rear Kettle Lid 1
859102 Crossbar Assembly 1
969714 Stir Rod 1
10 46649 Set Collar 3
11 47110 Knob Dump Handle 1
12 49314 RH Dump Handle 1
13 49362 Spacer Dump Handle 1
14 49328 Kettle Lead Assembly 1
15 47193 T ermostat S unt Bar 1
16 76702 T ermostat 525°F 1
17 76089 T ermostat 450°F 1
18 56006 Kettle / Heater 780W 1
19 49431 6Oz Kettle S ell 1
20 49368 Kettle Gasket 1
21 69715 Agitator Weig t 1
KETTLE BREAKDOWN
Kettle Part No. 56000
Relevant Models: 1866, 2085, 2086, 2656
1
2
4
3
5
6
7
8
9
10
11
12
13
14
15
17
16
18
19
20
21
13

P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
ttp://www.gmpopcorn.com Page 9
ITEM PART NO MODEL(S) PART NAME QTY
147060 BOTH Spur Gear 1
243434 BOTH Agitator Bearing Hub 1
347106 BOTH Needle Bearing 1
441742 BOTH Set Screw 4
569710 BOTH Agitator S aft 1
649017 BOTH Front Lid Wit Formed Lifter 1
749016 BOTH Rear Kettle Lid 1
49471N 2656KC Crossbar Assembly 1
49471XJN 1866XJ Crossbar Assembly 1
969714 BOTH Stir Rod 1
10 46649 BOTH Set Collar 3
47123 2656KC Knob Dump Handle Red 1
47110 1866XJ Knob Dump Handle 1
12 49314 BOTH RH Dump Handle 1
13 49362 BOTH Spacer Dump Handle 1
76707 2656KC 420 °F T ermostat 1
76089 1866XJ 450 °F T ermostat 1
15 76702 BOTH 525 °F T ermostat 1
16 47193 BOTH T ermostat S unt Bar 1
17 49532 BOTH Element Clamp 1
18 49328 BOTH Kettle Lead In Assembly 1
46652 2656KC 850W Tubular Element 1
48739 1866XJ Tubular Element 850W 100V 1
20 49431 BOTH Kettle S ell 1
21 49368 BOTH Kettle Gasket 1
49432 2656KC Kettle Weld Assembly 1
49596 1866XJ 6oz. Clad Kettle Weld Assy. 1
23 69715 BOTH Agitator Weig t 1
8
14
11
19
22
KETTLE BREAKDOWN
Kettle Part No. 49434KC (Model 2656KC)
49434XJN (Model 1866XJ)
3
4
5
7
8
10
11
12
13
1
2
6
9
13
23
14
15
16
17
2
2
18
19
20
2
1

P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
ttp://www.gmpopcorn.com Page 10
CABINET BREAKDOWN
Models No. ALL (2085-2656 S own)
1
2
-
3
4
5
-
6
7
-
8
9
10
11
12
13
-
14