Goldmedal Dogeroo User manual

Dogeroo & Super Dogeroo
Instruction Manual
Model #8102, #8102FC, #8103 and #8104
PartNo.87793
RevisedOct. 1998
Cincinnati, OH 45241-4807 USA

SAFETY PRECAUTIONS
NOTE
The information, specifications and illustrations contained in this manual represent
the latest data available at time of publication. Right is reserved to make changes as
required at the discretion of Gold Medal Products Company without notice.
Any alterations to this equipment will void the warranty and
may cause a dangerous situation. NEVER make alterations
to the equipment.
Always wear safety glasses when servicing this equipment.
Machine must be properly grounded to prevent electrical shock
to personnel.
Do NOT immerse the equipment in water.
Always unplug the equipment before cleaning or servicing.
This equipment is designed and sold for commercial use only. This
equipment is not to be used by the consumer in home use. Do not allow
direct contact of this equipment by the public when used in food service
locations. Only personnel trained and experienced in the equipment
operation may operate this equipment.
Carefully read all installation instructions before operating the equipment.
NEVER put your fingers or any object into the heating area.
We do NOT assume any liability for injury due to careless
handling or operation of this equipment.

Dogeroo and Super Dogeroo
MODELS #8102, #8102FC,#8103AND #8104
1
OPERATING INSTRUCTIONS
SPECIFICATIONS Dogeroo Super Dogeroo
Hot Dogs 56 84
Buns 40 60
Width 21 ½" 27 ½"
Height 28 ½ " 28 ½"
Depth 15 ½" 15 ½"
ShippingWeight 52 lbs. 67lbs.
PowerRequirements 1680Watts 1880Watts
INSTALLATION
1. Carefully remove the machine from the shipping cartons. Remove all packing material and
tape. Check thoroughly for any damage which may have occurred in transit. Claims should
be filed immediately with the transportation company.
2. The glass has been packaged for shipment and placed in the bun warmer basket. Remove
the package and carefully unwrap the glass.
3. Lift off the top frame assembly.
4. Insert glass into channel slots in corner posts and slide the glass down to the bottom of the
unit. CAUTION: Do not drop the glass. If the optional sneeze guard has been purchased,
place it over the corner posts.
5. Set the top frame assembly on the corner post. Make sure it is seated at each corner.
6. Place water pan in the top frame.
7. Place bun warmer on the top frame and slide the bun warmer basket into the warmer.
8. Place rotisserie in position. See page 3 for driveshaft assembly.
9. Be sure to place your Dogeroo where the revolving hot dogs will attract the most attention.
ELECTRICAL REQUIREMENTS
These machines are designed to operate at the voltage requirements and current indicated for
each machine. The power supply cord is equipped with a "machine ground" – the tubular prong
on the male plug. For safety, always plug your hot dog cooker into a grounded type receptacle.
The Dogeroo machine draws 12 amps. The Super Dogeroo machine draws 14.9 amps. Make
certain that the electrical outlet is capable of carrying this much current.
Machine must be properly grounded to prevent shock in case of
electrical problems.

Dogeroo and Super Dogeroo
MODELS #8102, #8102FC,#8103AND #8104
2
CONTROLS AND THEIR FUNCTIONS
ON/OFFSWITCH
Flipping the lever of this switch to the "ON" position will energize the drive motor which
rotates the rotisserie. It also lights the 40 Watt bulb behind the front glass and completes the
circuit to the heat control.
HEATCONTROL
The infinite heat control allows you to vary the operating temperature of the heating element.
When this control is in any position other that "OFF", the red pilot light will be on.
When the control is set at the "HI" position, the heating element is energized continually.
OPERATING PROCEDURE
1. Pour 1 ½ quarts of water into the water pan (about 5/8" deep). Do NOT overfill! Overfilling
will result in too much steam. This will keep the buns moist and warm. Use hot water to
speed the process.
2. Place buns in the bun warmer basket. (Some buns collect more moisture than others due
to their texture).
3. Place the hot dogs on the rotisserie.
4. When ready to start cooking, move the toggle switch to the "ON" position. This will rotate
the rotisserie clockwise and light the bulb behind the silk screened sign.
5. The time required to broil the hot dogs will vary, depending upon size and temperature
(35-37° F refrigerated) of the hot dogs when placed in the Dogeroo.
With the heat control set on "HI" and using average size hot dogs, it will take from 10-15 minutes
to have the hot dogs ready for 140° F minimum serving temperature. Watch the dogs carefully
the first several times you cook to avoid blistering or burning the hot dogs.
After the hot dogs are cooked, reduce the heat control setting to one which will keep the hot
dogs at the 140° F minimum serving temperature. Hot dogs can be kept on the rotisserie for
several hours without shriveling or loss of flavor, if the heat control is properly set.

Dogeroo and Super Dogeroo
MODELS #8102, #8102FC,#8103AND #8104
3
CARE AND CLEANING
Good sanitation practice demands that all food cooking equipment be cleaned regularly. A clean
llooking, well kept machine is one of the best ways of advertising your product.
The Dogeroo and Super Dogeroo have been designed to disassemble quickly, without the use of
special tools, for easy cleaning.
1. Disconnect power supply cord. Be sure unit has cooled sufficiently to permit safe handling.
2. Remove the condensate pan and basket from the bun warmer.
3. Remove the door from the bun warmer by sliding the pivot pin to the left or the right to
disengage.
4. Lift the bun warmer from the top of the top frame assembly. Lift out the water pan from the
top frame assembly.
5. Slide rotisserie to left and disengage from motor coupling. Lift the left end of the rotisserie
from the end support.
6. Lift the power assembly from frame. This assembly must be cleaned by wiping with a damp
cloth.
7. Lift out the drip pan. Slide the front and side glass upward in the slots designed in the
corner posts for glass removal.
8. All parts (except power assembly) may be immersed or flooded with water for cleaning.
Use a cleanser/sanitizer recommended or approved by your local Board of Health. Wipe
all parts dry.
9. Reassemble in reverse order.
Unplug your machine before cleaning.

Dogeroo and Super Dogeroo
MODELS #8102, #8102FC,#8103AND #8104
4
ORDERING SPARE PARTS
1. Identify the desired part by checking it against the photos, illustrations, and/or the parts list.
2. When ordering, please include part number, part name, and quantity desired.
3. Please include your model name and machine serial number (located on the machine
nameplate) with your order.
4. Address all parts orders to: Parts Department
Gold Medal Products Co.
10700 Medallion Drive
Cincinnati, Ohio 45241-4807
or, place orders at:
[phone]
Fax: [phone]
E-mail: [email protected]
NOTE: We do NOT ship glass. Obtain replacement glass from your local hardware store.
SIDE GLASS: 1/8" x 11 29/32" x 163/16
FRONTGLASS: 1/8"x 1329/32" x 16 3/16
1/8" x 19 29/32" x 16 3/16 (Super Dogeroo)
MAINTENANCE INSTRUCTIONS
THE FOLLOWING SECTIONS OF THIS MANUAL ARE IN-
TENDED ONLY FOR QUALIFIED SERVICE PERSONNEL WHO
ARE FAMILIAR WITH ELECTRICAL EQUIPMENT. THESE ARE
NOT INTENDED FOR THE OPERATOR.
Adequate eye protection must be used when servicing this
equipment to prevent the possibility of injury.
Do NOT immerse the equipment in water.
Unplug your machine before servicing.

Dogeroo and Super Dogeroo
MODELS #8102, #8102FC,#8103AND #8104
5
DOGEROO & SUPER DOGEROO ASSEMBLY

Dogeroo and Super Dogeroo
MODELS #8102, #8102FC,#8103AND #8104
6
DOGERROO AND SUPER DOGEROO PARTS LIST
MODEL NO.
ITEM # 8102 8102FC 8103 8104 DESCRIPTION
1 87037 87037 87121 87037 Door Assembly
2 87034 87034 87107 87034 Condensate Pan
3 87689 87689 87725 87689 Bun Warmer Basket
4 87685 87685 87723 87685 Bun Warmer, Dome
5 87690 87690 87726 87690 Water Pan
6 87082 87082 87116 87082 Drip Pan
7 87681 87681 87721 87681 Frame Weldment
8 87668 87668 87715 87668 Motor, Element Support
9 87669 87669 87669 87669 Cover, Control Panel
10 87671 87671 87717 87671 Heat ReflectorAssembly
11 87020 87020 87020 87020 End Support, Rotisserie
12 87740 n/a 87127 n/a Rotisserie Assembly
13 87738 n/a 87151 n/a Cradle
14 87737 87128 87153 87052 Rotisserie
15 87708 87708 87728 87708 SupportTube, Socket
16 11034 11034 11034 11034 Lamp Socket
17 87733 87733FC 87734 87734SP Name Switch Plate
18 42798 42798 42798 42798 On / Off Switch
19 87048 87048 87048 87048 HeatControl
20 87027 87027 87122 87027 Heat Element
21 87713 87713 87713 87713 Drive Motor Assembly
22 87065 87065 87065 87065 ApplianceLightBulb
23 87049 87049 87049 87049 Knob, Heat Switch
24 87691 87691 87691 87691 Side Glass
25 87692 87692 87727 87692 Front Glass
26 87040 87040 87040 87040 InsulatorBlock Element
27 47120 47120 47120 47120 Knob, Lift Lid

Dogeroo and Super Dogeroo
MODELS #8102, #8102FC,#8103AND #8104
7
DOGEROO & SUPER DOGEROO ELECTRICAL SCHEMATIC

WARRANTY
WE WARRANT to the original purchaser the Gold Medal equipment sold by us to
be free from defects in material or workmanship under normal use and service. Our
obligation under this warranty shall be limited to the repair or replacement of any
defective part for a period of six (6) months from the date of sale to the Original
Purchaser with regard to labor and two (2) years with regard to parts and does not
cover damage to the equipment caused by accident, alteration, improper use, voltage,
abuse, or failure to follow instructions.
THISWARRANTYISINLIEUOFALL OTHER WARRANTIES EXPRESSEDOR
IMPLIED,ANDOFALLOTHEROBLIGATIONSORLIABILITIESONOURPART,
INCLUDINGTHEIMPLIEDWARRANTYOFMERCHANTIBILITY.THEREARENO
WARRANTIES WHICH EXTENDBEYOND THE DESCRIPTION ON THEFACE
HEREOF. We neither assume, nor authorize any other person to assume for us, any
otherobligationorliabilityinconnectionwiththesaleofsaidGOLDMEDALequipment
or any part thereof.
The term “Original Purchaser” as used in this warranty shall be deemed to mean that
person, firm, association, or corporation who was billed by the GOLD MEDAL
PRODUCTSCOMPANY, or their authorized distributor, for the equipment.
THIS WARRANTY HAS NO EFFECT AND IS VOID UNLESS THE ORIGINAL
PURCHASER FIRST CALLS GOLD MEDAL PRODUCTS COMPANY AT
1-800-428-2676 TO DISCUSS WITH OUR SERVICE REPRESENTATIVE THE
EQUIPMENT PROBLEM, AND, IF NECESSARY, FOR INSTRUCTIONS
CONCERNING THE REPAIR OR REPLACEMENT OF PARTS.
NOTE: This equipment is manufactured and sold for commercial use only.
GOLD MEDAL PRODUCTS COMPANY
10700 Medallion Drive
Cincinnati, OH 45241-4807 USA