Graco FIRE–BALL 300 Air Motor Muffler Kit Operation manual

Instructions – Parts List
GRACO INC.ąP.O. BOX 1441ąMINNEAPOLIS, MNą55440-1441
Copyright 1989, Graco Inc. is registered to I.S. EN ISO 9001
FIRE–BALLR300
Air Motor Muffler Kit
Part No. 222559
307942D
GRACO PUMP
PART NO.
SERIAL
MAX AIR WPR
MAX FLUID WPR
SERIES
MPA bar psi
MPA bar psi
IMPORTANT
You cannot order parts or request service and
warranty information for the complete pump
without the information on the serial label.
Record all the information from the serial label in
these spaces. Keep this manual in a safe place
as an extra precaution.
Read warnings and instructions.

2307942D
Installation
Pressure Relief Procedure
PRESSURIZED FLUID HAZARD
The equipment stays pressurized until
pressure is manually relieved. To re-
duce the risk of serious injury from
pressurized fluid, accidental spray from the valve,
or splashing fluid, follow this procedure whenever
you
DAre instructed to relieve pressure
DStop dispensing
DCheck, clean, or service any system equipment
DInstall or clean dispensing devices
WARNING
NOTE: Reference numbers and letters in parentheses
in the text refer to the Parts Drawing on page 3.
MOVING PARTS HAZARD
Never operate the pump with the warn-
ing plate (1) or the identification plate (2)
removed. These plates protect your
fingers from getting pinched or amputated by
moving parts in the air motor.
WARNING
Replace the Muffler Plates
NOTE: You cannot order parts or request service or
warranty information without the serial label
information. Record the serial label (A) information on
the front of this manual as an added precaution. Keep
the manual in a safe place.
1. Unscrew the plate retaining screws and remove
the identification muffler plate and warning muffler
plate from both sides of the air motor. To avoid
twisting the screw heads off if the screws are hard
to remove, tap lightly on the screw heads with a
hammer, then remove them.
2. Discard the old identification muffler plate and
warning muffler plate. The muffler kit includes an
identification plate for one side and a warning plate
for the other side.
3. Install the two mufflers (1, 2) on the air motor as
shown on the Parts Drawing. Fasten the mufflers
to the air motor, using the plate retaining screws
(3).
4. With the air motor operating, check all around both
mufflers for air leaks. Adjust the plate retaining
screws if necessary.

307942D 3
Parts
REF PART DESCRIPTION QTY
NO. NO.
1 234577 MUFFLER, identification and
serial plate side 1
2 234578 MUFFLER, warning plate side 1
3 100078 SCREWS, plate retaining
No. 8–32 x 0.375 in. 12
A Serial label
1
2
3
A

4307942D
Graco Standard Warranty
Graco warrants all equipment manufactured by Graco and bearing its name to be free from defects in material and workmanship on the
date of sale to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco,
Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be
defective. This warranty applies only when the equipment is installed, operated and maintained in accordance with Graco’s written
recommendations.
This warranty does not cover, and Graco shall not be liable for general wear and tear, or any malfunction, damage or wear caused by
faulty installation, misapplication, abrasion, corrosion, inadequate or improper maintenance, negligence, accident, tampering, or sub-
stitution of non–Graco component parts. Nor shall Graco be liable for malfunction, damage or wear caused by the incompatibility of
Graco equipment with structures, accessories, equipment or materials not supplied by Graco, or the improper design, manufacture,
installation, operation or maintenance of structures, accessories, equipment or materials not supplied by Graco.
This warranty is conditioned upon the prepaid return of the equipment claimed to be defective to an authorized Graco distributor for
verification of the claimed defect. If the claimed defect is verified, Graco will repair or replace free of charge any defective parts. The
equipment will be returned to the original purchaser transportation prepaid. If inspection of the equipment does not disclose any defect
in material or workmanship, repairs will be made at a reasonable charge, which charges may include the costs of parts, labor, and
transportation.
THIS WARRANTY IS EXCLUSIVE, AND IS IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT
NOT LIMITED TO WARRANTY OF MERCHANTABILITY OR WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE.
Graco’s sole obligation and buyer’s sole remedy for any breach of warranty shall be as set forth above. The buyer agrees that no other
remedy (including, but not limited to, incidental or consequential damages for lost profits, lost sales, injury to person or property, or any
other incidental or consequential loss) shall be available. Any action for breach of warranty must be brought within two (2) years of the
date of sale.
Graco makes no warranty, and disclaims all implied warranties of merchantability and fitness for a particular purpose in connection
with accessories, equipment, materials or components sold but not manufactured by Graco. These items sold, but not manufactured
by Graco (such as electric motors, switches, hose, etc.), are subject to the warranty, if any, of their manufacturer. Graco will provide
purchaser with reasonable assistance in making any claim for breach of these warranties.
In no event will Graco be liable for indirect, incidental, special or consequential damages resulting from Graco supplying equipment
hereunder, or the furnishing, performance, or use of any products or other goods sold hereto, whether due to a breach of contract,
breach of warranty, the negligence of Graco, or otherwise.
FOR GRACO CANADA CUSTOMERS
The parties acknowledge that they have required that the present document, as well as all documents, notices and legal proceedings
entered into, given or instituted pursuant hereto or relating directly or indirectly hereto, be drawn up in English. Les parties reconnais-
sent avoir convenu que la rédaction du présente document sera en Anglais, ainsi que tous documents, avis et procédures judiciaires
exécutés, donnés ou intentés à la suite de ou en rapport, directement ou indirectement, avec les procedures concernées.
Graco Information
TO PLACE AN ORDER, contact your Graco distributor, or call one of the following numbers
to identify the distributor closest to you:
1–800–367–4023 Toll Free
612–623–6921
612–378–3505 Fax
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
Sales Offices: Minneapolis
International Offices: Belgium, Korea, Hong Kong, Japan
www.graco.com
PRINTED IN USA 307942 02/1989, Revised 07/2004