Grizzly Tool Storage User manual

TOOL BOXES AND ROLLER CABINETS
Please read these instructions carefully
Tool Boxes
Boxes that have no front locking panel are equipped with a locking
mechanism actuated by the lid. When the lid is closed, tabs in the lock
bar engage the pockets on the drawers. When the lid is open, the tabs
are raised clear of the pockets.
Important: The drawer must be fully closed before the lid is shut. DO NOT
slam the drawers when the lid is shut; they will not lock and damage to
lock bar tabs or lock pockets may occur. Should this happen, remove
the drawer and straighten out the deformed tab with a screwdriver. For
the lock pockets, a pair of pliers should be used. See (1A) lock bar tab
and (1B) lock pocket.
Removal/Re-installation of Drawers:
• To remove, pull drawer fully open. Push in the plastic tabs (2) on both
sides to release drawer from slides. Pull the drawer out.
• To re-install, line up the drawer slides, engage, and close the drawer
completely.
Roller Cabinets
The roller cabinets feature a rotating cam lock mechanism controlled
by a key. When locked, hooks engage in each drawer to prevent them
from being opened. When unlocked, the hooks disengage, allowing the
drawers to be opened. If the cabinet is locked while the drawers are still
open, simply close the drawers to lock them.
Casters and Side Tray: Use the included screws to attach the two
heavy-duty fixed casters (3A) and two heavy-duty swivel casters with
brakes (3B) as shown in the diagram. The side handle/tool tray (3C)
must be attached to the same side as the swivel casters.
Removal/Re-installation of Drawers:
• To remove, pull drawer fully open. Push in the plastic tabs (4) on both
sides to release drawer from the slides. Pull the drawer out.
• To re-install, line up the drawer slides, engage, and close the drawer
completely.
Lubrication
To ensure smooth operation of the slides, lubricate them periodically
with a light grease or petroleum jelly. Do this at least twice a year or
more, depending on the frequency of use.
1A
1B
4
2
3B
3A
3C
Push